Sony NYSNO-10 Help Manual page 67

careful when communicating using BLUETOOTH wireless technology.
We do not take any responsibility for the leakage of information during BLUETOOTH communications.
Connection with all BLUETOOTH devices cannot be guarantee.
A device featuring BLUETOOTH function is required to conform to the BLUETOOTH standard specified by
Bluetooth SIG, Inc., and be authenticated.
Even if the connected device conforms to the above mentioned BLUETOOTH standard, some devices may not
be connected or work correctly, depending on the features or specifications of the device.
While talking on the phone hands free, noise may occur, depending on the device or communication
environment.
Depending on the device to be connected, it may require some time to start communications.
On charging the main unit
This main unit can be charged using USB only. Personal computer with USB port is required for charging.
This main unit cannot be turned on, nor can the BLUETOOTH function be used, during charging.
If you do not use the main unit for a long time, the rechargeable battery may not be able to keep sufficient charge.
The battery will be able to keep a charge properly after repeatedly discharging and charging several times.
If you store the main unit for a long time, charge the battery once every half year to prevent over-discharge.
If the length of time you can use the unit became extremely short, the rechargeable battery should be replaced with a
new one. Visit the Company support site for battery replacement:
https://www.sony.net/Products/NYSNO/support/
If NYSNO-10 does not operate properly
Reset the main unit and remote control.
Press the RESET button with something fine-tipped such as a hairpin until you feel the button. The pairing
information and the other settings are retained.
1. RESET button
If the problem persists even after the resetting operation above, initialize the main unit as follows.
Press and hold the RESET button for about 15 seconds with something fine-tipped such as a hairpin.
The lamp (blue) flashes 4 times, and the main unit is reset to the factory settings. All pairing information is deleted.
After the main unit is initialized, it may not connect to your iPhone or computer. In this case, delete the pairing
information of the main unit from the iPhone or computer, and then pair them again.
Others
As the main unit makes sounds by vibrating the helmet shell, sound leakage may occur outside the shell. When
using NYSNO-10, pay attention to your surroundings. Adjust the volume, turn down the volume instantly with the
Attenuate (ATT) function, etc. as necessary.
When you talk on Group Talk, beeping (howling) may occur depending on the range between main units. In this case,
adjust the range.
Do not place the main unit in a place exposed to humidity, dust, soot or steam, or subject to direct sunlight. Do not
leave the main unit in a car for a long time. It may cause a malfunction.
Using the BLUETOOTH device may not function on mobile phones, depending on radio wave conditions and location
where the equipment is being used.
67