Kalkomat COMBO PRIZE Technical Information page 16

DOWN and on the main board (depending on bag position) HI – LO
shows this would indicate that the sensor is working.
2 Check if sensor cable is firmly connected to the main board.
3 Check all wires to / from sensor.
Halogen lights are not functioning:
1 Check power supply cable connection.
2 Check power supply wire integrity.
3 Check connector plug for lose bulb.
4 Check if halogen is not burned by swapping it with a new one (12V
20W).
Button START or RANDOM is not functioning:
1 Check for main board cable connection.
2 Check switch/button cable connection.
Power supply is refusing to work:
1 Check if "car" fuse in main board (left bottom) is not burned 30A
(green).
2 Check if transformer cable is correctly hooked up to power supply
socket.
Machine is not starting:
1 Check power cable fuse 5A.
2 Check if filter is not damaged.
Bill Acceptor is not functioning:
1 Check if power supply cable is hooked up to main board (BILL).
2 Check if cable from bill acceptor is correctly hooked up.
3 Check acceptor settings. For switches 1-8 set switch no 7 at ON,
and for switches 1-4, set switches no 3 and 4 at ON.
Sound is not working:
16