Lcd Panel - HP Aruba 7010 Series Installation Manual

LCD Panel

The Aruba 7010 controller is equipped with an LCD panel (see
the controller's status and provides a menu that allows basic operations such as initial setup and reboot. The LCD
panel displays two lines of text with a maximum of 16 characters on each line. When using the LCD panel, the active
line is indicated by an arrow next to the first letter.
The LCD panel is operated using the two navigation buttons to the right of the screen.
Menu: Allows you to navigate through the menus of the LCD panel.

Enter: Confirms and executes the action currently displayed on the LCD panel.

LCD Mode Menu
The LCD mode menu includes four modes as shown in the following table.
Table 8 LCD Panel Mode
LCD Mode Function
Boot Displays the boot up status.
LED Displays the mode of the
STATUS LED.
The LED mode menu allows
you to choose what
information is communicated
by the STATUS LEDs on each
port. See
for descriptions of the LED
behavior of each mode.
Status Displays the ArubaOS version.
Maintenance Allows you to execute some
basic operations of the Aruba
7010 controller such as
uploading an image or
rebooting the system.
| 7010 Controller
12
Displays
"Booting ArubaOS...
LED mode: ADM
LED mode: DPX
Table 5 on page 10
LED mode: POE
LED mode: SPD
Exit
OS Version
Exit
Upgrade Image [Partition 0
[Y|N] | Partiion 1 [Y|N]]
Upload config [Y | N]
Factory Default [Y|N]
Media Eject [Y| N]
Reload system [Y|N]
Halt system [Y|N]
Exit
Figure 4 on page 10.) that displays information about
Description
Displays boot status.
Administrative– Displays whether the port is
administratively enabled or disabled.
Duplex– Displays the duplex mode of the
port.
PoE– Displays if port is taking PoE power or
not.
Speed– Displays the speed of the port.
Exits LED menu.
Displays the ArubaOS version.
Exits Status menu.
Allows you to upgrade the software image on
the selected partition from a predefined
location on an attached USB flash device.
Uploads the controller's current configuration
to a predefined location on the attached USB
flash device.
Allows you to reset the device to factory
default settings.
Completes the reading or writing of the
attached USB device.
Allows you to reboot the device.
Allows you to halt the device.
Exits Maintenance menu.
Aruba 7010 Series Controller
| Installation Guide