Uplink Ports - HP Aruba 7010 Series Installation Manual

The following table describes the LED behavior for each mode:
Table 5 10/100/1000BASE-T Ethernet Port LEDs
LED Function LCD Mode
LINK/ACT Link N/A
status
STATUS Port Administrativ
status e
Duplex
PoE
Speed

Uplink Ports

The Aruba 7010 controller includes two 1000BASE-X uplink ports (16 and 17). See
Aruba supported SFP transceivers in these ports.
Figure 4 Ports, LEDs, and LCD Panel
| 7010 Controller
10
Indicator Status
Green (Solid) Link has been established
Green Port is transmitting or receiving data
(Blinking)
Off No link on port
Green (Solid) Port enabled
Off Port Administratively disabled
Green (Solid) Full-duplex
Off Half-duplex
Green (Solid) PoE enabled
Green Power enabled, but power denied due to
(Blinking) unavailability
Off PoE not enabled
Green (Solid) 1000 Mbps
Off 10/100 Mbps
Figure 4. It is recommended to use
Aruba 7010 Series Controller
| Installation Guide