Factory Reset - Ihse Draco MultiView 4K60 MV42 Series User Manual
Hide thumbs
Also See for Draco MultiView 4K60 MV42 Series:
- Quick setup (2 pages) ,
- User manual (234 pages)
Table of Contents
Advertisement
Draco Multiview 4K60
7.6.3
Factory Reset
If you perform a (factory) reset, all current settings and all configurations stored in the Draco MV
will be lost. This also applies to the network parameters (reset to DHCP) and the admin
password.
If a firmware update has been installed since the delivery, the Draco MV will be set to the state
defined there
To perform a reset of the Draco MV, proceed as follows:
1. Select Configuration > Factory Reset in the main menu.
2. Confirm the selection with the Okay button.
The current configuration in the permanent memory of the Draco MV is deleted and the
Draco MV will be reset to factory settings.
Menu Factory Reset
Fig. 76
NOTICE
NOTICE
Operation
95
Advertisement
Table of Contents
Need help?
Do you have a question about the Draco MultiView 4K60 MV42 Series and is the answer not in the manual?