Ihse Draco MultiView 4K60 MV42 Series User Manual page 64

Configuration via Management Software
The following parameters can be configured:
Field
Enable Syslog
Syslog Server
Port
Log Level
To set parameters for the syslog function, proceed as follows:
1. Select System Settings> Network in the task area.
2. Select the Syslog tab in the working area.
3. Modify the desired settings.
4. Click the Apply button to confirm your entries.
64
Entry Description
Check Syslog server to query status is active
Byte Input of the IP address of the syslog servers in the form
"192.168.1.1"
Byte Input of the syslog ports (default: 514)
DEB Activate debug messages in syslog (default: N)
Note: The debug messages are exclusively for Draco MV
diagnostics. Use this function only for concrete debug
cases as it is not intended for normal operation.
INF Activate information messages in syslog (default: N)
NOT Activate notification messages in syslog (default: Y)
WAR Activate warning messages in syslog (default: Y)
ERR Activate error messages in syslog (default: Y)
Draco Multiview 4K60