Ihse Draco MultiView 4K60 MV42 Series User Manual page 46

Configuration via OSD
SNMP Agent
You can activate the SNMP agent by setting Y (Yes):
Traps
Enable
SNMP Server
You can activate the following traps by setting Y (Yes):
Traps
Enable Traps
Server Address
Status
Power Supply #1
Power Supply #2
Switch Command
Insert Output
Remove Output
Input Video Info
EDID Change
Activating the SNMP agent
To activate the SNMP agent, proceed as follows:
 Select Configuration > SNMP in the main menu.
 Set the Enable option to Y (Yes) within SNMP Agent.
By activating this option, the permission for an active query of the SNMP agent is granted.
Configuring a SNMP server
To configure a SNMP server, proceed as follows:
1. Set the Enable Traps option to Y (Yes) within SNMP Server.
This function allows an active transmission of trap messages from the SNMP agent to the
SNMP server.
2. Set the IP address of the SNMP server within Server Address.
3. Activate the requested traps by enabling them to Y (Yes).
46
Description
Permission for an active query of the SNMP agent for traps is granted.
Description
Activation of the monitoring via traps
Input of the IP address of the SNMP server in the form "192.168.1.1" and
of the SNMP port (default server 1: 161, default server 2: 162)
Notification about Draco MV status
Notification about the status of power supply unit #1
Notification about the status of power supply unit #2
Notification about a performed switching operation at the Draco MV
Notification about a newly connected to the Draco MV

Notification about a switched-on console

Notification about a removed console from the Draco MV

Notification about a switched off console

Notification about a change of resolution or change of frequency
Notification about a change in EDID information at the inputs
Draco Multiview 4K60