Ihse Draco MultiView 4K60 MV42 Series User Manual page 42

Configuration via OSD
Network Services
Field
API Service
SSL
Syslog #1/#2
Syslog Server #1/#2
Log Levels
Field
Trace
Syslog #1/#2
Activate the modified network parameters by restarting the Draco MV.
To set parameters for the network configuration, proceed as follows:
1. Select Configuration > Network in the main menu.
2. Modify the desired settings.
3. Click the Okay button to confirm your entries.
42
Entry Description
Y LAN interface at the Draco MV activated for access via
management software (API service port 7055)
N Function not active (default)
Y Activate SSL encryption for API, management software
API, management software and Draco MV communication
N Function not active (default)
Y Syslog server for status request is active
N Function not active (default)
Byte Input of the IP address of the syslog servers in the form
"192.168.1.1" and of the syslog port (default: 514)
Entry Description
DEB Activate debug messages in trace (default: N)
Note: The debug messages are exclusively for Draco MV
diagnostics. Use this function only for concrete debug
cases as it is not intended for normal operation.
INF Activate information messages in trace (default: N)
NOT Activate notification messages in trace (default: Y)
WAR Activate warning messages in trace (default: Y)
ERR Activate error messages in trace (default: Y)
DEB Activate debug messages in trace (default: N)
Note: The debug messages are exclusively for Draco MV
diagnostics. Use this function only for concrete debug
cases as it is not intended for normal operation.
INF Activate information messages in trace (default: N)
NOT Activate notification messages in trace (default: Y)
WAR Activate warning messages in trace (default: Y)
ERR Activate error messages in trace (default: Y)
NOTICE
Draco Multiview 4K60