Bosch Indego M 700 Original Instructions Manual page 30

30 | English
Main Menu Sub-menu 1
Tools
Troubleshooting
Online Support
http://www.bosch-indego.com
Problem Possible Cause
The LED on the dock- The perimeter wire is interrupted, too long
ing station flashes or too short. Wire not connected and
mower not in the docking station.
Excessive vibrations/ Blade bolt loose
noise
Cutting blade damaged/bent
Mower not docking Perimeter wire not properly layed out
reliably around docking station
Perimeter wire close to a source of interfer-
ence
Mower fails to operate Isolator switch not turned on
F 016 L81 041 | (15.04.2020)
Sub-menu 2 Explanation
Garden Overview Displays the number of mapped gardens, their size, their wire ID
and the date of the last time the garden was cut.
Delete garden Delete one specific garden map or select to delete all maps at
once.
Name mower Change the name shown in the display. Only letters of the Latin al-
phabet are possible. The number of letters is limited. This function
is not available in every language.
In some languages (e.g. Czech or Polish) a name change doesn't
have any effect on display due to specific grammar requests.
Level check Information about the ground angle of the mower. If the mower is
in the docking station and the dot on the display is not within the
indicated circle, the docking station must be mounted at a new,
more level location.
Wire signal Detects the wire signal received from the perimeter wire, indicat-
ing its strength (for Service Agent).
The mower will not receive a wire signal while in the docking sta-
tion.
Corrective Measure
Check that the perimeter wire is not interrupted and is
between 20 and 350 meters in length. Then switch
power supply off and then on again.
Follow instructions in Installation Guide to install the
mower.
Tighten blade bolt to torque of 2.5 Nm.
Replace cutting blade (see figure J).
Follow instructions in Installation Guide on layout of peri-
meter wire.
Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
Remove mower out of docking station, turn isolator
switch on and place mower back into docking station (en-
sure docking station is on – LED lights up green).
Bosch Power Tools