Bosch Indego M 700 Original Instructions Manual page 27

Mowing
Do not let children ride the mower.
u
Press the stop button on top of the mower before lift-
u
ing. Always lift the mower by its handle. (see figure F)
Make sure the cutting area is free of small animals such as
hedgehogs or tortoises.
Only with Indego M 700: After successful installation you
can either immediately begin to mow by confirming "Mow
now" on the display, or wait for the next scheduled cutting
period, as programmed by the "Bosch AUTO" Calendar
Function (previous setting required).
A manual mowing schedule can also be set up according to
your specific needs.
Only with Indego M+ 700: After successful installation, you
can begin mowing immediately by confirming "Mow now"
on the display, or on the free Bosch Smart Gardening App by
pressing "mow". You could also set up a programmed
schedule, using the Bosch "SmartMowing" functionality,
which can also plan future cutting sessions based on when it
is forecasted to rain. You could also set up a programmed
schedule in the calendar using the display or the Bosch
Smart Gardening App.
The mower must mow a garden 3 times completely (do 3 full
cuts) to learn the garden. During the learning phase, the
visual result may not be optimal.
Approximate runtimes for complete garden coverage using
LogiCut are listed below. Please note that the runtimes will
vary depending on the lawn complexity and number of ob-
jects within the garden.
2
100 m 4 h
2
500 m 16 h
2
700 m 22 h
Set a schedule with frequent repetitions. This achieves good
mowing results, the battery charge will last longer and you
avoid debris on the lawn.
When the mower is mowing
In "manual" mode, the mower works until the lawn is
mowed. Mowing is interrupted only for charging the battery.
When the garden is mowed, the mower returns to the dock-
ing station.
In the programmable "Schedule" mode, with the "Bosch
AUTO" calendar function or with the Bosch "SmartMow-
ing" functionality, the mower operates continuously for a set
period of time. Mowing is interrupted only for charging the
battery. If the garden is mowed before the time period ex-
pires, the mower returns to the dock.
To stop mowing prematurely, press the Stop button or send
the mower back to the docking station pressing the confirm
button ✓.
With Indego M+ 700 you can send the mower back to the
docking station, by pressing the "Dock" button on the free
Bosch Smart Gardening App.
Bosch Power Tools
Energy saving mode
The mower reduces its energy consumption by automatically
switching off the power in the perimeter wire when it is not
mowing and not being charged.
To wake up the mower manually from the energy saving
mode, press the confirm button ✓and afterwards select
either "Mow now" or another "Mowing mode", while the
mower is in the docking station.
With Indego M+ 700 you can wake up the mower remotely
from the energy saving mode, by pressing the "mow" button
on the free Bosch Smart Gardening App.
For mowing based on an active schedule or with the "Bosch
AUTO" calendar function or with the Bosch "SmartMow-
ing" functionality, the energy saving mode is automatically
ended.
Mowing small lawn areas with „SpotMow"
SpotMow is intended for mowing small areas that require
special treatment without having to mow the whole lawn,
such as the area under a piece of garden furniture that has
been removed. The mower is positioned at the lower left
corner of the intended area to mow (see figure H). The final
mowed area depends on the lawn conditions; it will not ne-
cessarily be an exact square. After completion of „Spot-
Mow", follow the instructions on the screen.
Note: For safety reasons, „SpotMow" cannot be used outside
the perimeter wire.
Sensors
The mower is equipped with the following sensors:
– The lift-up sensor is activated when the mower is lifted.
– The rollover sensor detects when the mower tips over.
– The tilt sensor is activated when the mower reaches a
slope angle of 32°.
When one of the sensors is activated, e.g. the lift-up sensor,
the drive motors and cutting blades are stopped. A message
is indicated in the display, e.g. "lift-up".
– The obstacle sensor detects objects/obstacles alongside
the entire front edge of the mower and causes a change of
direction.
Battery charging
The battery is equipped with temperature monitoring that al-
lows charging only if the battery internal temperature is in
the range between 5 °C and 45 °C.
The lithium-ion battery is supplied partially charged. It is re-
commended to charge the mower during installation of the
perimeter wire in the docking station.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
When the battery is run flat or discharged, the mower is shut
off by means of a protective circuit: the blades no longer
move.
English | 27
F 016 L81 041 | (15.04.2020)