Changing Engine Oil - Mercury 5 HP FourStroke Propane Operation, Maintenance And Installation Manual

3. Lubricate the propeller shaft with Extreme Grease or 2‑4‑C with PTFE.
(Refer to Propeller Replacement for removal and installation of the
propeller.) Coat the entire propeller shaft with lubricant to prevent the
propeller hub from corroding to the shaft.
Tube Ref
Description
No.
Extreme Grease
2-4-C with PTFE
95

Changing Engine Oil

Discharge of oil, coolant, or other engine/drive fluids into the environment is
restricted by law. Use caution not to spill oil, coolant, or other fluids into the
environment when using or servicing your boat. Be aware of the local
restrictions governing the disposal or recycling of waste, and contain and
dispose of fluids as required.
ENGINE OIL CAPACITY
The engine oil capacity is approximately 450 ml (15 fl oz).
OIL CHANGING PROCEDURE
1. Place the outboard in an upright (not tilted) position.
2. Turn the outboard to gain access to the drain plug. Remove the drain plug
and drain the engine oil into an appropriate container. Lubricate the seal
on the drain plug with oil and install.
eng
MAINTENANCE
Where Used
Propeller shaft
Propeller shaft
NOTICE
41
68645
8M0071842
92-802859A 1
Part No.