Cisco ONS 15454 Install page 28

Install the shelf and backplane cable

Hide thumbs Also See for ONS 15454:

Table of Contents

NTP- A11 Install the Rear Cover

Figure 1-11

EIA Labeling on the Mounting Bar

Mounting holes

for all other EIAs

UBIC-V/UBIC-H

mounting hole

Tighten the two screws (48-2116-01) for each mounting bar.

Step 6

Repeat Steps

Step 7

Attach the rear cover (700-06029-XX) by hanging it from the mounting screws on the back of the

Step 8

mounting bars and pulling it down until it fits firmly into place

(Figure

Cisco ONS 15454 Procedure Guide, Release 8.5.1

1-28

and

for the second mounting bar.

1-13).

Chapter 1 Install the Shelf and Backplane Cable

UBIC-H

mounting hole

UBIC-V

mounting hole

(Figure

1-12) or by using standoffs

78-18537-01

Table of Contents