Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Morris MDE-4019
Summary of Contents for Morris MDE-4019
- Page 2 Rendering of Whole Dehumidifier Please read this manual carefully before use, and keep it properly for future reference.
-
Page 3: Table Of Contents
TABLE of CONTENTS 2. Contents 17. Air Purification and Use of Strainer 3. Precaution 19. Description of Air Purification Function 7. Notices During Use 19. Description of Air 9. Spare Parts of Product Purification Function 10. Ti ps 20. Drainage 11. -
Page 4: Precaution
PRECAUTIONS Meanings of legends are as follows PROHIBITION Please prohibit such operations for the sake of you and your families’ safety and health. COMPULSORY DUTY Please see to it for the sake of you and your families’ health. - Page 5 Compulsory Duty The power supply applicable to this dehumidifier is Please put this dehumidifier in smooth and solid single-phase 220-240V, if voltage is 10% higher or places to reduce vibration and noise. lower than normal voltage, this dehumidifier will not able to operate normally and even the fuse is burnt out, the dehumidifier is easy to be damaged, so it is recommended to provide voltage regulator.
- Page 6 Compulsory Duty This appliance is intended to be used in household Please do not place this dehumidifier in water or other and similar applications. liquids. Please do not incline in case that water in tank Please do not put articles on this dehumidifier. overflows.
- Page 7 Compulsory Duty For abnormalities (such as emission of burnt flavor For long-time operation, if the dehumidifier is used or smoke, etc.), if any, please shut down this with fuel gas appliances in the same room, please dehumidifier and pull out power plug, and contact ventilate air frequently.
- Page 8 Precautions During Use On condition that automatic drainage function is used, please guarantee that the level of drainage pipe is not over the height of outlet, otherwise your floor is easy to get wet. For use of this dehumidifier, please make sure that the space around the dehumidifier is over 30cm.
- Page 9 The relationship between volume of dehumidification and temperature is shown in figure on the right. The rated volume of dehumidification is measured at 30℃ and 80% relative humidity. The ambient temperature for use of this dehumidifier is 5℃~32℃. The optimal temperature range for use is 16-32℃, and relative humidity is 30-85%.
-
Page 10: Spare Parts Of Product
SPARE PARTS OF PRODUCT F ront sid e Control Panel PP Strainer Air Purification Assembly (HEPA or Activated Carbon Strainer) Deco r at i n g Pl ate o f Fro n t Pa ne l Inlet Grid Back Sid e Handle Water Tank Cover... -
Page 11: Operating Panel
A Few Tips Operating Panel 1. Before running please pour off water in tank; 2. During running please do not open windows and doors as much as possible so as to save energy; 3. When installing the dehumidifier, see to leave a certain space around the dehumidifier, specifically over 50cm on the top and over 30cm in front, back, left and right directions, as shown in figure below. - Page 12 , air...
-
Page 13: Display Screen
DISPLAY SCREEN Display Screen Cloth Dry Ventilation Powerful Dehumidifying Drying Patterns Air Purify Auto Dehumidifying Child Lock Patterns Temperature and Timer display Patterns Full Water Alaem Strainer Pattern Patterns Humidity Display Low-temperature Strainer use timingPattern Patterns Anion Pattern Sleep Pattern Air Speed and Swing Pattern DRYING PATTERN: flickers in internal drying mode;... -
Page 14: Operating Methods
OPERATING METHODS Operating Methods Insert Power Plug Please assure consistency of power supply for the dehumidifier with power grid. The operating voltage for this dehumidifier is 220-240V~50Hz. Press POWER, the Dehumidifier Starts Operation. This dehumidifier is complete with power-down memory function. - Page 15 Timing Shutdown During operation of the dehumidifier, slightly touch TIMER, 88 on LCD will flicker for 5 times for confirmation, at the moment touch TIMER to adjust the set time as required, and the method is the same as that for startup. Auto Dehumidification Initial startup of the dehumidifier defaults auto dehumidification mode or select this mode via MODE.
- Page 16 Cloth dry function Select this item, compressor will started and fun speed will be high, then it is effcient to dry the wet cloth. And in this mode, you clould press “Swing button” to change the angle of deflector. Tips In the above three dehumidification modes, if the air purification pattern (two small trees) flickers, it is not fault, but the strainer (H E P A or activated carbon) is not removed, and air purifying function is performed with dehumidification.
- Page 17 Tips Tips When it is humid and clothes are not easy to dry, operate in powerful dehumidification mode to dry, operate and press SWING, enabling auto swing of air swing blades to enlarge air supply range and g of air swing blade effectively feed dry air to each corner for faster and more effective drying of clothes fectively feed dry air to each corner for faster and more effective drying of clothes ffective drying of clothes...
-
Page 18: Air Purification And Use Of Strainer
AIR PURIFICATION AND USE OF STRAINER Air Purification and Use of Strainer Purification function Slightly touch button MODE to select this mode, first judge whether the strainer (HEPA strainer or activated carbon strainer) is installed or not, if installed, the purification pattern displays constantly, the fan starts high-speed air operation, air speed can be regulated via setup button HUMIDITY and is circularly selected among high-speed air low-speed air. - Page 19 Air purification strainers (HEPA strainer and activated carbon strainer) Step 1 Open decorating plate of front panel Step 2 Embed strainer for air purification (activated carbon strainer or HEPA strainer) into plastic framework. Step 3 Recover decorating plate of front panel after the above two steps.
-
Page 20: Description Of Air Purification Function
DESCRIPTION OF AIR PURIFICATION FUNCTION A c t i v a t e d Ca r b o n St r a i n e r ( Op t i o n a l ) H i g h-efficiency HEPA Strainer ( Op t i o n a l ) Preset PP Strainer Activated carbon strainer... -
Page 21: Drainage
DRAINAGE Use of water tank When water tank is full of water, the icon for full water on LCD flickers, and BUZZE sounds for 10 times to remind the user till water is poured off. Put hand at depressed place on the bottom of water tank and take it out slightly, remove water tank cover and pour off water in tank. - Page 22 Continuous drainage mode If you are not intended to pour water in tank off frequently, a drainage pipe (with inner diameter of 9mm) can be connected on the back of this dehumidifier for drainage, but it should be bought at your own cost.
-
Page 23: Maintenance
MAINTENANCE Cleaning of strainer PRECAUTIONS 1. Pull out power plug before maintenance or repair in case of electric shock; 2. Only PP strainer in this dehumidifier can be cleaned; PP Strainer PP Strainer 3. If the PP strainer is not very dirty, it is only only required sucking dust out of the surface with dust collector... - Page 24 Cleaning of dehumidifier appearance 1. Please clean water tank or its cover with soft cloth dipped in cold water or warm water so as to avoid mildew inside; 2. If the dehumidifier is indeed very dirty, neutral cleaning agents can be used to wipe; After wiping, fix power line and entangle the whole dehumidifier with plastic bag of dehumidifier body or other bags to avoid pollution by flying dust, etc.
-
Page 25: Trouble Shooting
TROUBLE SHOOTING The following problems if occurring to the dehumidifier can be solved based on the solutions as follows. CONDITIONS POSSIBLE CAUSES SOLUTIONS Is power plug not well inserted? Insert power plug into socket. Is water in tank full? Dehumidifier does Pour water in tank off, and then (Water in tank is full or water not run...
Need help?
Do you have a question about the MDE-4019 and is the answer not in the manual?
Questions and answers