Page 32
*Press and hold this button for 3 seconds to enter the child lock mode, the child lock indicator lights up, and other touch button touches are invalid; after pressing and hold this button for 3 seconds, the child lock indicator light is off, and other touch button touches are effective.
Page 33
Timer then use timer (1-24 hrs, start/ stopping timer). In power on mode the set number will represent the number of hours the unit will run for before turning off. This will remain unaffected if unit goes represents the period in hours after which the unit will start. To cancel start / stop mode press Humidity Buttons: Press the Up or Down...
Page 34
3 minutes delay before compressor will start. Lightweight Portable Design on castors Your MORRIS dehumidifier is an advanced micro-CPU controlled device able of self- diagnostics. The LCD display may also show the error and protections codes.
Page 35
ensure circulation of air in not restricted around the unit. Allow at least 20 cm space around the unit. This dehumidifier is designed only for indoor residential / small office applications and any commercial or industrial use will invalidate the warranty.
Page 36
NOTES: the unit to operate. Your device has a drainage port that allows you to have continuous drainage. Connect a 10mm end of the hose is lower than occur. direct the pipe to a suitable drainage point. This unit uses gravity fall to dispose water hence the NOTE: When the continuous drain feature is not being used, remove the drain hose from the to lift the water upwards.
Page 37
outlet grilles get soiled easily, so use a vacuum attachment or soft brush to clean. Wipe the Remove the ABS frame and pull out the filters from the frame. Hoover gently the thoroughly before reinserting it in the unit. reassemble the unit. NOTE: While the carbon filter is optional never run the unit without the mesh...
Troubleshooting: Issue Cause Solution Hot or cold Normal Operation When the unit is in dehumidifying mode it absorbs humid air air being from room and freezes it to reduce the humidity. produced During the cold cycle there should be cold air coming out of the unit.
50 Hz 390W 290W 180m 42 dB(A) max R290 /95g 15.3 kg 0.7MPa 3.2MPa DECLARATION OF CONFORMITY irective: 14 / 30 / ow Voltage irective: 14/ 35 / irective: ( )15/863 The detailed declaration of conformity can be found at www.morris.gr...
Need help?
Do you have a question about the MDE-20200i and is the answer not in the manual?
Questions and answers