INSTRUCTION MANUAL DEHUMIDIFIER MDE-1215 www.morris.gr Please keep this manual carefully for further reference! Thank you for selecting our super quality dehumidifier. Please be sure to read this manual carefully before using it. Any questions, please contact the professional service for help. Keep the manual for future reference.
CAUTIONS Please read the operating instructions carefully before using your dehumidifier for the first time. Install the unit on flat and hard floor to diminish vibration or noise. Never immerse the unit in water or other liquids. Never operate the unit if the cable or other connector is damaged, or something abnormal may happen, please call customer service for help.
PARAMETER Model No. MDE-1215 Dehumidify Capacity 12L/day(30℃ RH80%) Rated Voltage AC220-240V Rated Frequency 50Hz Input Power 235W(30℃ RH80%) Rated Current 1.25A(30℃ RH80%) Water Tank Capacity Sound Pressure Level ≤43dB(A) Refrigerant Charge R134a/130g Net Weight 10.5kg Suction Side Pressure 0.5MPa Discharge Side Pressure...
PARTS A: Touch panel F: Turbofan K: Compressor B: Top air outlet G: Motor L: Float C: Side air inlet H: Condenser M: Water Tank D: Side panel I: Evaporator N: Three layers of filter(Optional) E: Purify component (Optional) J: Temperature and humidity sensor O: Back air inlet...
OPERATIONS POWER When power is on, the panel shows blue. Press this button to turn on /off the unit. Do not unplug the power cord directly to force the machine stop working directly. Press the “POWER” key, machine run and enter CONT (Continuously dehumidification)mode automatically.
Page 7
HUMSET Press this key, the system exit the CONT mode, enter the smart mode. Press this button to adjust humidity as following (The initial humidity is 60%), from 60%→ 65%→ 70%→ 75%→ 80%→ 40%→ 45%→50%→ 55%→60%. When the indoor humidity is lower than the set humidity, the machine would stop automatically. After set the humidity in 5 seconds, the machine show the current environment humidity.
Page 8
Double “88” display 1. When the machine is running, show the current humidity, 2. When we set the humidity, show the humidity of we set. 3. When we set the timer, show the time of we set. 4. When we long press “HUMSET” in 3 seconds, show current humidity. When current humidity<20%, shows “LO”...
WATER DRAINAGE Water Tank The Water full indication will show red when water tank is full, warning will be given. Take out the water tank(FIG 1), empty the water inside. Put the water tank back into the dehumidifier Continuous drainage Take out the water tank first, and connect the pipe with the outfall closely (FIG 2), the other side connection with floor drain on other container such as a bucket (FIG 3), at last put the water tank into the dehumidifier.
MAINTENANCE NOTE: TURN OFF THE UNIT AND UNPLUG IT BEFORE ANY MAINTENANCE OR REPAIR TO AVOID ELECTRIC SHOCKS. Cleaning Unplug the unit before any cleaning. Clean the housing with a soft moisture cloth. Do not use chemical solvent (such as benzene, alcohol, gasoline).The surface may be damaged or even the whole case may be deformed.
TROUBLE SHOOTING BEFORE CALLING FOR SERVICE Before contacting professional service, review this list. It may save your expense and time. This list includes common occurrences that are not the result of a defect in workmanship or materials. Problem Possible Cause Solution Connect to a functioning outlet and No power supply...
Page 12
Rohs Directive: 2011/65/EU declare that the dehumidifier EN 55014-1/A2:2011 EN 55014-2/A2:2008 EN 61000-3-2/A2:2009 EN 61000-3-3:2013 EN 60335-2-40/A13:2012 EN 60335-1:2012 EN 62233: 2008 www.amiridis-savvidis.gr...
Need help?
Do you have a question about the MDE-1215 and is the answer not in the manual?
Questions and answers