Download Print this page

olympia electronics SLIM LIGHT Series Manual page 2

Maintained/non-maintained (optional) luminaire

Advertisement

Indication LED status
The
status of the indication LEDs is described
in the diagram below.
ÁÔÔÅÍÔÉÏÍ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only
.
2.
The device must be connected to the mains
power supply thru a fuse dependent by the
total amount of the line's power load
3.
In case of inactive use for a period greater
than 2 months, disconnect the battery by
removing the battery enable jumper.
4.
I s not allowed to discard batteries in to
t i
common trash bins, they must be discarded
only
in battery recycling points. Do not
incinerate.
Indication LED status
LED
Explanation for the indication Led status
Continuously On
The green led, in case of remote control operation blinks showing that receives signal from
remote control
Page
2
from
4
:
.
Description
Normal operation
Battery charge
Charging fault disconnected battery
,
LED lighting test
LED lighting fault
Emergency duration check (automatic or manual)
Battery fault
Battery and LED lighting fault
LED lighting fault or mains power supply failure and LED lighting fault
(
Charger fault or battery fault (
or battery fault
)
Charger fault, battery fault and LED lighting fault
(
or mains power supply failure and battery fault and LED lighting fault
Continuously Off
.
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained
A: Including test device
180: 3 hour duration
INSTALLATION
To install the luminaire follow the installation
instructions which are described on page 4.
Important note
installed on the same site and
avoid the simultaneous automatic
month duration testing
The installer must first connect the battery
to the
luminaire
luminaire
to the
ensuring that there is a time difference of
>90 seconds between connections. This
ensures non-simultaneous automatic
control autonomy (the difference is at least
1 day).
, absence
of mains power supply
or mains power supply failure and charger fault
Blinks
,
luminaires which
we
want to
.
and then connect the
mains power supply
)
)
923200000_09_003
are
six-
,

Advertisement

loading

This manual is also suitable for:

Gr-2000