olympia electronics Slim Light Series Quick Start Manual

'' Slim Light '' SERIES FOR MAINTAINED / NON-MAINTAINED LUMINAIRES
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES (Ni-Cd)
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
ILLUMINATION (230V AC / emergency)
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
Thank you for purchasing this product of
O l y m p i a E l e c t r o n i c s . A E u r o p e a n
manufacturer.
GENERAL
These luminaires are used indoors (ta 40 C)
where emergency light is needed.
Each luminaire must be permanently
connected to mains power supply. In normal
operation the illumination LEDs are lit as well
as the green indicating charge LEDs when
the battery is charging.
In case of a mains power supply failure the
luminaire will light the led strip automatically
in emergency mode. When the mains power
supply is restored the device turns to normal
operation.
Maintained / non-maintained operation
there is an option to select the maintained or
non-maintained operation by placing the
jumper to the appropriate place according to
the figure 3 (page 2).
INSTALLATION
To install the luminaire follow the installation
instructions on page 2.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only.
2. The device must be connected to the
mains power supply thru a fuse dependent by
Page 1 from 2
High Quality European based Manufacturers
GR-8/leds
220-240V AC/50-60Hz
2.7W / 3VA
3.6V/0.6Ah
Battery charge indication LEDs, TEST button
1.5 h
35lm / 85lm
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
Bayblend FR3010, transparent polycarbonate
345gr.
3 years (1 year for the battery)
the total amount of the line's power load.
3. It is sugested to check every month the
indication LED for battery charging, and by
pushing the TEST button to check the
emergency circuit. The led strip should light as
o
long as the TEST button is pressed.
luminaire doesn't work as described above
contact the installer.
4. It is sugested to check every 6 months the
m i n i m u m a u t o n o n o u s d u r a t i o n b y
disconnecting the mains power supply. Count
the time that the led strip lights and in case of
less time than the minimum autonomous
duration the battery must be replaced. If the
measured time is considerably less than the
minimum autonomous duration
installer.
replacement, these must be replaced by parts
of the same type, by the manufacturer or by a
competent person.
5. In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery's connector.
6. I s not allowed to discard batteries in to t i
common trash bins, they must be
discarded only
points. Do not incinerate.
GR-9/leds
3W / 3.5VA
3.6V/1Ah
24 h
12 white LED's
32lm / 85lm
IP 20
o
5 to 40 C
Up to 95%
240 x 90 x 44 mm
350gr.
In case of battery or led strip
in battery recycling
923378005_23_001
3 h
If the
contact the