Advertisement
Performed by continuous
the button is pressed
Within 5 seconds the
of the 10 seconds the green and red LEDs stay on When these LEDs stay on release the test
button and the luminaire will operate as maintained or non-maintained depending on the
previous mode of operation.
the red indication led will blink once. During the change of operation from non-maintained to
maintained the red indication led will blink twice.
-
Activation Deactivation
/
Performed by continuous
the button is pressed
Within 5 seconds the
the green and red LEDs light
If you release the button immediately
deactivated, depending on
indication led will blink once and when is reactivated the orange indication led will blink twice.
-
Light adjustment
By pressing continuously the test button for 5 seconds, the luminaire will light in 30% of the
nominal luminosity. If the test button is pressed again for 5 seconds the luminaire will light again
in 100% of the nominal luminosity.
LIGHT SENSOR
The light sensor when activated, controls the LED lighting
connected to the mains power supply
maintained luminaire
the LED lighting
guidelines of the European Union. It should therefore be taken
of
the luminaire is
simple rule for installation is: keep minimum distance of 0.5m from the ceiling and 1.5 m from
the wall on the test button side.
1
A
1
In order to install the luminaire you need to insert a flat blade screwdriver in region
separates the plastic hooks to remove the plastic cover as shown to the picture. Do the same for
the Cover on the other side of the luminaire.
2 Use the support materials contained in
Attention
!!! The luminaire should be placed
with the power supply cable entry of the luminaire
3
Put the battery's jumper slot onto the board as shown
cord to terminal
s
4 Re-in
stall
carefully the plastic covers removed in step 1 and the device is ready to
powered by the mains power supply
Page
4
from
4
ly
pressing
the button
:
faults are cleared
During the change of operation, from maintained to non-maintained,
Light sensor
ly
pressing
the button
:
faults are cleared
and
in
15 seconds the red
after the orange LED lights
the previous state
(only in emergency mode).
. When
the
lighting
turns off
so as not to
relative to other light sources
Installation procedure of the luminaire
Cable
Entry
L
for phase
and N for neutral.
for 10 seconds.
(the 3
indication LEDs light se
.
(
with mains power supply present)
for 15
seconds. The following will occur when
(the 3
indication LEDs light se
goes OFF and the
.
When the sensor is deactivated, the orange
operation and not
of
the area where the
consum
e unnecessary energy, as defined
in order
2
the
packaging
to mount the luminaire to a flat wall
in such a way as to align the power cables
.
in
The following will occur when
quentially) and
.
quentially),
orange LED
the light sensor is activated or
of the
GR-2000 only
in emergency mode, operating as
luminaire is placed
into account
that the installation
to ensure smooth operation.
3
the picture
. Connect the power
923200000_09_003
at the end
in 10 seconds
lights
.
when it is
is sufficient,
by t
he
One
L
N
A
, so it
be
Advertisement
