Table of Contents
Advertisement
Firmware version will be displayed by scanning "$SW#VER".
Firmware Version:
Netum barcode scanners are factory programmed for the most common
Barcode Programming
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an option indicates the default setting.
Many command barcodes only work with scanner in a particular connection
Important Notes :
mode. Please pay attention to below symbol when you scanning the command
barcodes.
Command barcodes only apply to scanner work via Bluetooth connection.
Command bacodes only apply to scanner work via Wireless Connection.
Command bacodes only apply to scanner work via USB Wired Connection
Scanner can be connected to your device via bluetooth, USB receiver or USB
Connection Way
cable, you can choose one of the connection way to connect scanner with
your device.
Get Started: Connect scanner with your device via USB cable. If you use US
Working Via USB Cable
keyboard, it's plug and play. If you use other type of keyboard , please refer to
"keyboard language" to con�igure the keyboard language before you use it.
$SW#VER
(2)
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the C Series and is the answer not in the manual?
Questions and answers