Related Manuals for NORDIC SEASON Buffalo 3
Summary of Contents for NORDIC SEASON Buffalo 3
- Page 1 Buffalo 3 3 BURNER GAS BBQ GG201821B READ THE OPERATING INSTRUCTIONS BEFORE USING THE APPLIANCE. FOR OUTDOOR USE ONLY. INSTRUCTION AND USER MANUAL OUTDOOR USE ONLY!
-
Page 2: Table Of Contents
Gas category ...................4 Exploded drawing................5 Parts list ...................6 Hardware ..................7 Assembly instructions ..............8 Gas leak test .................16 Connecting gas ................17 Before using the grill ..............18 Grilling tips..................19 Lighting instructions ...............20 Warnings ..................21 Maintenance................... 22 Troubleshooting ................23 Consumer Contact .................24 Buffalo 3... -
Page 3: Warnings
WARNINGS Failure to follow the instructions provided can imply a risk of serious injury to personnel and fixed installations. Some grill parts can be sharp, we recommend wearing gloves when assembling and lifting. Sharp edges can cause injury. The grill is intended for outdoor use only in well-ventilated areas. Never grill in enclosed spaces or under a roof, due to the danger of the lack of oxygen. -
Page 4: Technical Data
LPG 37mbar G30 (butane), Grill burner: G31(propane) AT, CH, DE, SK I3B/P(50) 0.80mm and mixture of these, LPG 50mbar This product is produced according to EUROPEAN GAS APPLIANCE STANDARD EN498 AND EN484 and is CE certified. Buffalo 3... -
Page 5: Exploded Drawing
Exploded Drawing... -
Page 6: Parts List
Left side table Right side table Knob bezel Knob Flame tamer Cooking grate Warming rack Drip tray Grease cup Matchstick holder assy Thermometer Ignition button When ordering spare parts, please use the code from parts list found here. Buffalo 3... -
Page 7: Hardware
Hardware The following screws and nuts are supplied with the grill and must be fitted. 1 pcs 1 pcs 1 pcs Small spanner Axle washer M6 screw 16 pcs 16 pcs M6x12 screw Lock washer 10 pcs M4x8 screw 9 pcs 9 pcs M6x16 screw M6 Lock washer... -
Page 8: Assembly Instructions
Attach the four legs to bottom panel Using M6x12 screws and M6 lock washers secure left leg assembly (part 2) to bottom panel (part 1) and right leg assembly (part 3) with corresponding screws. Assemble 2 additional legs in same manner (see illustration). Buffalo 3... - Page 9 Assembly M6 x12 screw, 8 pcs. M6 lock washer, 8 pcs. Install the front panel Insert the corresponding M6x12 screws with M6 lock washers into the pre drilled holes of the left and right legs located at the front of the cart. Do not tighten screws. Line up the slots in the front panel (part 4) to the screws.
- Page 10 Install left and right drip tray brackets M4 x 8 screw, Lock the left bracket for drip tray (part 6) and right bracket for drip 4 pcs tray (part 5) into the mounting hole at left and right leg assembly with corresponding M4x8 screws. Buffalo 3...
- Page 11 Assembly Install the firebox and hood assembly Place the knob (part 13) on the valve stem (see illustration). Set the firebox and hood assembly (part 9) on top of the cart panel. Secure the firebox and hood assembly with M6x16 screws and M6 washers at the top of each leg of the cart (see illustration).
- Page 12 Line up the holes in the right side burner table (part 11) with the pre-installed screws on right side of firebox and hood as- sembly. Slide right side table into place over the screws. Tighten the pre-installed screws to secure the side table. Buffalo 3...
- Page 13 Assembly Install flame tamers Place the 4 flame tamers (part 14) over each burner inside the firebox. Vented end of flame tamer is placed toward the back of the firebox (see illustration). Install the cooking grate Place the cast iron cooking grate (part 15) into the firebox.
- Page 14 Install the drip tray and grease cup Insert the drip tray (part 18) into the drip tray brackets from the back of the grill. Insert the grease cup (part 17) into the brackets on drip tray (see illustration). Buffalo 3...
- Page 15 Assembly Install matchstick holder assy. and M6 x16 skruv, 1 st. ignitor battery M6 låsbricka, 1 st. M6 x16 screw, 1 pcs. Install M6X16 screw and M6 lock washer M6 lock washer, 1 pcs. at the 2/3 position of back left leg of cart. Do not tighten screw.
-
Page 16: Gas Leak Test
IF BUBBLES APPEAR, SWITCH OFF THE GAS SUPPLY AND REPAIR THE PROBLEM. PERFORM A NEW LEAK TEST. DO NOT USE THE GRILL BEFORE YOU ARE SURE THAT THERE ARE NO LEAKS. If there are still gas leaks after repeated attempts, contact your dealer. Buffalo 3... -
Page 17: Connecting Gas
Connecting Gas ALWAYS perform a gas leak test before using the grill. Hose Gas bottle Check the gas hose regularly Connect the gas hose to the gas for cracks and decay. Never rail inlet on the left hand side of the use a damaged gas hose. -
Page 18: Before Using The Grill
Check that the gas hose is free of cracks and damage (it should always be done before using the grill). Check that the gas bottle and hose do not come into contact with hot objects. Buffalo 3... -
Page 19: Grilling Tips
Grilling tips A CLEAN GRILL WORKS BETTER, causes less smoke and prevents fat catching fire. Burn off the grill after use by opening the lid and burning all the burners at full power for 10 minutes. Allow the grill to cool, and then brush off ash from flame tamers and grates. -
Page 20: Lighting Instructions
Switch off the gas supply at the bottle, then turn all control valves to the NEVER DOUSE THE “Off” position. GRILL WITH WATER Wait until the barbecue is sufficiently cool WHEN THE SURFACES before closing the hood. ARE HOT. Buffalo 3... -
Page 21: Warnings
WARNING Always keep an eye on the grill when in If storing the grill in a garage or use. Never allow children or others who require basement below ground level, do not store the supervision near the grill when in use. gas bottle the same place, as it must be stored above normal ground level. -
Page 22: Maintenance
When using a grill cover, the grill must be clean when they are dry. and dry and sufficient ventilation must be ensured. If not, moisture will accumulate under the cover causing Check that the gas hose is not rust damage. damaged by mice or rats. Buffalo 3... -
Page 23: Troubleshooting
Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION Empty gas bottle Replace gas bottle Damaged regulator Check/replace the regulator Burner is blocked Clean the burner Gas supply is blocked Clean gas ventury or hose BURNER WILL NOT LIGHT Electrode is broken or dirty Clean the electrode Place the BBQ in a less Windy conditions... -
Page 24: Consumer Contact
Always attach your receipt and product serial number when making a warranty claim. This can be found of the carton or the CE-label. We reserve the right for any misprints or changes in the specifications. Produced in China for Nordic Season Asia Co., Ltd.