Table of Contents
Advertisement
Testing Sequence:
There are seven basic steps required to test the battery state of charge:
NOTE:
The unit cannot be charging to test the battery voltage.
1.
With the charger unplugged from the AC outlet, connect the
charger to the battery following the instructions given in Sections
6 and 7.
2.
Plug the charger AC power lead into the AC outlet.
3.
The CONNECTED (
connected battery is detected.
4.
Confirm the CHARGING (
5.
Set the DISPLAY to VOLTS
6.
If the output is on, press the Start/Stop (
is already off, do not press the Start/Stop (
7.
Read the voltage on the digital display.
General Charging Notes
Fans:
The charger is designed to control its cooling fans for efficient operation.
Consequentially, it is normal for the fans to start and stop when maintaining
a fully charged battery. Keep the area near the charger clear of
obstructions to allow the fans to operate efficiently.
NOTE:
The charger has thermal protection, and it will shut down if it gets
too hot.
Voltage:
The voltage displayed during charging is the charging voltage and is usually
higher than the battery's resting voltage.
) LED will light yellow if a properly
) LED is off.
19
) button. If the output
) button.
Advertisement
Table of Contents
