Table of Contents
Advertisement
Flash Reprogramming
NOTE:
Do not attempt to Flash Reprogram a vehicle that has a discharged
or defective battery. Make sure that the vehicle battery is in good condition
and fully charged before proceeding.
1.
Set MODE to FLASH REPROGRAM. (The VOLTS LED will start
blinking.)
2.
Use "UP" and "DOWN" (
the voltage needed for the vehicle being programmed (refer to
OEM specifications). Voltage selected is shown on the digital
display. The unit has a voltage range of 13 to 14.8, with a default
of 14.2.
NOTE:
the selected voltage.
3.
Press Start/Stop (
4.
When finished with Flash Reprogramming, press Start/Stop (
button to exit this mode.
Using the Battery Voltage Tester
Overview
This battery charger has a built-in voltmeter to measure your battery's
voltage. The charger does not have a built in load tester. As such, a recently
charged battery could have a temporarily high voltage due to what is known
as "surface charge". The voltage of such a battery will gradually drop during
the period immediately after the charging system is disengaged.
Consequently, the tester could display inconsistent values for such a battery.
For a more accurate reading, the surface charge should be removed by
temporarily creating a load on the battery, such as by turning on lights or
other accessories for a couple of minutes before you read the display. Read
it a couple of minutes after you have shut the headlights off.
When the VOLTS LED stops blinking, the display shows
) button to turn on the output.
and
) buttons to adjust voltage to
18
)
Advertisement
Table of Contents
