Control Panel - Westfalia 900001506599 Owner's Manual

9.1 Slide all 4 brackets (Item 1) into the track on the back, from the right side,
as shown above. Make sure the set screws (Item 2) are unscrewed
enough so they do not scratch the surface of the housing.
9.2 Measure what you are mounting the charger to before deciding where to
locate the brackets (add an additional ¼ to ½ inch). Use the ruler on the
label (Item 3) to mount the brackets (Item 1) in the correct position
(position each bracket an equal distance from the center of the charger).
Note that the inches shown are for both bracket dimensions combined
(meaning the dimensions are doubled), this is for easier reference. Make
sure the ¼-28 set screws (Item 4) are unscrewed enough so the pointed
end is almost flush with the bracket. Mount the brackets (Item 1) by
tightening all 8 set screws (Item 2) to 14 in/lb (1.6 n/m) of torque.
9.3 Lift the charger by its handle and set it against your mounting location,
tighten the set screws (Item 4) to 66 in/lb (7.5 n/m) of torque to secure
the brackets (Item 1) starting with the top two brackets first
10.

CONTROL PANEL

CONNECTED (yellow) LED
The CONNECTED (
connected.
CHARGING (yellow) LED
When charging begins, the CHARGING (
CHARGED (green) LED
The CHARGED (
maintain mode.
"UP" and "DOWN" (
Use these buttons to select the amount of time or voltage depending on the
display function selected.
Start/Stop (
This is the start and stop button for all modes.
) LED will light yellow when the battery is properly
) LED will light green when the charger has gone into
and
) Button
) LED will light yellow.
) Buttons
11