Advertisement
These instructions describe the Magnum 224 LTO library (224), the StorageLibrary T24 (T24), and the
StorageLoader 2U LTO (2U). Please read the entire section that you are using prior to beginning the procedure.
P
I
REPARING FOR
Note:
If your library is installed in a rack, it is not necessary to remove the library from the rack to complete this
procedure. It is also not necessary to disconnect the Ethernet cable from the back of the library.
Obtain these items—a #2 Phillips screwdriver and a small flat-blade screwdriver.
✔
Ensure that the environment is free of conditions that could cause electrostatic discharge (ESD)—If possible,
✔
use an antistatic mat and a grounded static protection wristband during installation. If a mat and wristband
are not available, touch a known grounded surface, such as a computer's metal chassis.
Warning
Warnung
Advertencia
G
I
ENERAL
NFORMATION
All of the libraries accommodate Ultrium 4 (LTO-4), Ultrium 3 (LTO-3), or Ultrium 2 (LTO-2) tape drives and half
height (HH) or full height (FH) configurations. None of the libraries accommodate LTO-1 tape drives.
The tape drives must be specially configured (at the factory) for use in the libraries. Purchase
! Important
tape drive kits only from Tandberg Data or Tandberg Data-approved suppliers.
To view this information...
Installing additional tape drives
Replacing a tape drive with the same configuration
(half height -to- half height or full height -to- full height)
Replacing a half height tape drive with a full height tape drive
Reconfiguring the library
Resuming operation
Confirming the installation
2
12
OF
NSTALLATION OR
Before performing any installation or maintenance procedures, be sure that the library's
power switch is off and that the power cord is disconnected from the library and the
outlet.
Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu achten, daß
der Library-Netzschalter auf "Aus" gestellt ist und daß das Anschlußkabel vom Library
und der Steckdose entfernt ist.
Antes de realizar cualquier procedimiento de instalación o de mantenimiento,
comprobar que el interruptor de alimentación de la biblioteca está apagado y que el
cable de alimentación no está enchufado ni a la biblioteca ni a la toma de corriente.
(this step must be completed for the library to
R
EPLACEMENT
operate)
go to...
page 5
page 7
page 9
page 10
page 11
page 12
Advertisement
