Service Program Mode; Service Program Mode Operation; Entering And Exiting Sp Mode - Ricoh B022 Service Manual

4.2 SERVICE PROGRAM MODE

4.2.1 SERVICE PROGRAM MODE OPERATION

The service program mode is used to check electrical data, change modes, and
adjust values. Two service program modes are provided:
• SP Mode (Service). Includes all the options in the SP displays for normal
maintenance and adjustments.
• SSP Mode (Special Service). Includes the normal SP modes and some
additional options in the SP displays not required for normal settings and
adjustments. (Most are marked "DFU" in the following tables.) Do not change
these important settings needlessly. For details, contact your supervisor.

Entering and Exiting SP mode

1. Press the Clear Mode key.
2. Use the keypad to enter "107".
3. Hold down Clear/Stop for at least 3 seconds.
4. Enter the Service Mode.
Copy SP
Copy SP
Exit 5. Press Exit twice to return to the copy window.
NOTE: Use SP2-902 to perform test pattern printing. (
SM
To enter the Normal Service Mode:
On the touch-panel, press Copy SP.
To enter the Special Service Mode:
Hold down and then press Copy SP.
4-3
SERVICE PROGRAM MODE
4.2.3)
B022/B027