Switching Between Sp Mode And Copy Mode For Test Printing; Selecting The Program Number - Ricoh B022 Service Manual

Switching Between SP Mode and Copy Mode for Test Printing

1) In the SP mode, select the test print and then press Copy Window.
2) Use the copy window (copier mode), to select the appropriate settings
(paper size, etc.) for the test print.
3) Press Start
4) Press SP Mode (highlighted) to return to the SP mode screen and repeat
from step 1.

Selecting the Program Number

Program numbers have two or three levels.
1. Before you begin, refer to the Service Tables to find the SP that you want to
adjust. ( 4.2.2)
2. Press the Group number on the left side SP Mode window that contains the SP
that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the
SP number that you want to open, and then press that number to expand the
list.
4. Use the center touch-panel buttons to scroll to the number and title of the item
that you want to set and press. The small entry box on the right is activated and
displays the default or the current setting below.
NOTE: Refer to the Service Tables for the range of allowed settings. (
1. To enter a setting
• Press
to toggle between plus and minus and then use the keypad to
enter the appropriate number. The number you enter writes over the previous
setting.
• Press
to enter the setting. (If you enter a number that is out of range, the
key press is ignored.)
• When you are prompted to complete the selection, press Yes.
2. If you need to perform a test print, press Copy Window to open the copy
window and select the settings for the test print. Press Start
press SP Mode (highlighted) in the copy window to return to the SP mode
display.
3. When you are finished, press Exit twice to return to the copy window.
SM
to execute the test print.
4-5
SERVICE PROGRAM MODE
B027S501.WMF
4.2.2)
twice, and then
B022/B027