Page 1
The Steps for updating the firmware of Z-9000 1. Power off the Z-9000 unit. 2. Press 8 and the Power key at the same time to enter Program Manager. 3. Use the up/down arrow keys to select “1. Download “ and press Enter (blue key)
Page 2
Please install the Z-9000 driver if necessary. 6. On your computer, please open the Boot Load Utility (default path: Start>All Programs>ZEBEX>ZAC>Boot Load Utility). 7. Check the Device Manager on your computer for the COM port Z-9000 is using.
Page 3
9. Select “Load File” then select the Z-9000 firmware file stored on your computer. 10. Select “Start Boot Load" to transfer the file to Z-9000. You will hear a beep sound when the transfer is done. The Download screen appears on the Z-9000 screen.
Page 4
Select “2. Activate” then select the file slot you selected in step 4 and press enter. 11. Press FN and 3 at the same time to activate the file. 12. A message appears on the screen “Are you sure to activate file?” Use the up/down arrow keys to select “YES”...