Related Manuals for Zebex Z-3272
Summary of Contents for Zebex Z-3272
- Page 1 Z-3272 Hanheld 2D Image Reader Service Guide Revision History Changes to the original manual are listed below: Version Date Description of Version January 17, 2017 Initial release...
-
Page 2: Preface
This scanner is in conformity with CE standards. Please note that an approved, CE-marked power supply unit should be used in order to maintain CE conformance. This manual is in A4 format. Please check your printer setting before printing it out. Z-3272 Service Guide 2 / 11... -
Page 3: Table Of Contents
Table of Contents Preface..................................2 Important Notice ..................................2 Radio Notice...................................2 Radio and Television Interference............................2 For CE-Countries ...................................2 Table of Contents................................3 Scanner Parts ..................................4 Take Apart ..................................5 Before You Start ..............................6 Important Instructions ..............................6 Tools to Prepare ..................................6 Z-3272 Service Guide 3 / 11... -
Page 4: Scanner Parts
ERVICE UIDE Scanner Parts The scanner includes the following parts: Z-3272 Service Guide 4 / 11... - Page 5 UIDE Name Quantity 863-327200-201 Z-3272 top case assembly 863-3172P0-702 Z-3172Plus handle base assembly 863-327202-704 Z-3272 2D engine assembly (HD)-repair 863-327202-705 Z-3272 2D engine assembly (SR)-repair 564-0172P0-001 Z-3172Plus handle base cover -SR 863-3172P1-401 Z-3172Plus dust cover assembly –repair 560-0172P0-001 Z-3172Plus trigger 521-002000-6R0 Self tapping screw,M1.6-6.0mm...
-
Page 6: Take Apart
Follow all instructions. • Heed all warnings. Tools to Prepare • Philips screwdriver. Please follow these steps to take apart the scanner. Remove the screws (521-00E000-8R0). Separate the top case from the handle base. Z-3272 Service Guide 6 / 11... - Page 7 ERVICE UIDE Remove the dust cover from handle base. Remove the screws (521-002000-6R0*4) and the washers. Remove Mylar tape then remove the 16Pin FFC cable. Z-3272 Service Guide 7 / 11...
- Page 8 ERVICE UIDE Remove the main board and handle base. Remove the main board and the buzzer. Remove the screws (521-00E000-8R0*2). Z-3272 Service Guide 8 / 11...
- Page 9 ERVICE UIDE Remove the trigger and the I/O board assembly 10. Remove the screw (521-00E000-8R0). 11. Separate the base cover and the handle base Z-3272 Service Guide 9 / 11...
- Page 10 ERVICE UIDE 12. Remove the Mylar tape. 13. Remove the 16Pin FFC cable. 14. Remove the screws (521-013000-5R0*3). Z-3272 Service Guide 10 / 11...
- Page 11 ERVICE UIDE 15. Separate the trigger support and the rubber. Z-3272 Service Guide 11 / 11...