Page 1
ICE DISPENSER Model D3030-1 Installation Manual Part No. 91718 Revised: August, 1995 THIS DOCUMENT CONTAINS IMPORTANT INFORMATION This Manual must be read and understood before installing or operating this equipment IMI CORNELIUS INC; 1989-95 Ó PRINTED IN U.S.A...
GENERAL DESCRIPTION The D3030-1 ice dispensers solve your ice and beverage service needs in a sanitary space saving, economical way. Designed to be manually filled with ice from any remote ice-making source, these dispensers will dispense cubes (up to 1-1/4? in size), cubelets and hard-chipped or cracked ice.
INSTALLATION INSTRUCTIONS 1. Locate the dispenser indoors on a level counter top. Unpack the four (4) legs and install them into the threaded holes provided in the bottom of the unit. 2. Connect the 3/4? IPS (or equal) drain line to the 3/4? threaded drain connections at the lower rear of the unit.
CLEANING INSTRUCTIONS WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage may result. Do not use solvents or other cleaning agents, as they may attack the plastic material.
DAILY or as required Remove foreign material from vending area sink to prevent drain blockage. WEEKLY or as required Clean the vending area. Check for proper water drainage from the vending area sink. MONTHLY Clean and sanitize the hopper interior. (See cleaning instructions). If the dispenser fails to dispense ice when operated, check that the hopper has ice in it and that power is being supplied to the unit.
TROUBLESHOOTING Should your unit fail to operate properly, check that there is power to the unit and that the hopper contains ice. If the unit still does not dispense, check the following chart under the appropriate symptoms to aid in locating the defect.
ICE LEVEL SIGNAL GROUND OPTION T’ STAT LIGHT LIGHTED DISPLAY OPTION BALLAST LIGHT STARTER GATE SOLENOID 1 1/4 AMP TIME 24 V. DELAY FUSE TRANSFORMER BEVERAGE TERMINAL FAUCET SWITCH (TYPICAL) OPTION BOARD AGITATOR BEVERAGE SYSTEM MOTOR PORTION PORTION TIMER CONTROL OR RED OPTION DISPENSE...
FIGURE 4. SOLENOID ASSEMBLY EXPLODED VIEW AND PARTS LIST Index Part No. Qty. Name 21493 Solenoid Mounting Plate 31551 Solenoid Service Kit 70171 8--32 x 3/8 Phil Tr HD Screw 70121 No. 8 Lockwasher 50752 Isolator 50789 Bumper Assembly 70423 Cotter Pin 10080 Gate Lift Rod...
IMI Cornelius Inc. warrants that all equipment and parts are free from defects in material and workmanship un- der normal use and service. For a copy of the warranty applicable to your Cornelius product, in your country, please write, fax or telephone the IMI Cornelius office nearest you. Please provide the equipment model number and the date of purchase.
Page 13
IMI CORNELIUS INC. CORPORATE HEADQUARTERS: One Cornelius Place Anoka, Minnesota 55303-6234 (612) 421-6120 (800) 238-3600...