Table of Contents
Advertisement
Quick Links
Installation Manual
Publication Number: 91719
Release Date: April 01, 1994
Revision Date: May 09, 2014
Revision: B
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or operating this equipment
© CORNELIUS INC; 1989-2014
ICE DISPENSER
Model D100/D150
PRINTED IN U.S.A
Advertisement
Table of Contents
Related Manuals for Cornelius D100
Summary of Contents for Cornelius D100
- Page 1 Publication Number: 91719 Release Date: April 01, 1994 Revision Date: May 09, 2014 Revision: B THIS DOCUMENT CONTAINS IMPORTANT INFORMATION This Manual must be read and understood before installing or operating this equipment © CORNELIUS INC; 1989-2014 PRINTED IN U.S.A...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Page SAFETY PRECAUTIONS ........... GENERAL DESCRIPTION . -
Page 3: Safety Precautions
Designed to be manually filled with ice from any remote ice-making source, these dispensers will dis- pense cubes (up to 1-1/4? in size), cubelets and hard-chipped or cracked ice. Table 1. Specifications Model: D100 D150 Ice Storage: 100 lbs. -
Page 4: Installation Instructions
INSTALLATION INSTRUCTIONS 1. *Locate the dispenser indoors on a level counter top. Unpack the four (4) legs and install them into the threaded holes provided in the bottom of the unit. 2. Connect the 3/4? IPS (or equal) drain line to the 3/4? threaded drain connections at the lower rear of the unit. -
Page 5: Operating Instructions
OPERATING INSTRUCTIONS START-UP AND OPERATING INSTRUCTIONS Fill the hopper with ice and replace the lid. Pushing the dispenser lever will cause ice to flow from the ice chute. Ice flow will continue until the lever is released. If ice does not dispense see the TROUBLESHOOTING GUIDE to find the cause. -
Page 6: Gate Restrictor Plate
GATE RESTRICTOR PLATE CAUTION: Disconnect power to dispenser before installing, removing or adjusting restrictor. INSTALL PLATE ON STUDS AS SHOWN FIGURE 1. GATE RESTRICTOR PLATE ADJUSTMENT This dispenser is provided with a gate restrictor plate, installed in it’ s highest position. This plate adjusts the rate of ice flow from the dispenser. -
Page 7: Troubleshooting Guide
TROUBLESHOOTING GUIDE Should your unit fail to operate properly, check that there is power to the unit and that the hopper contains ice. If the unit does not dispense, check the following chart under the appropriate symptoms to aid in locating the defect. -
Page 8: Figure 2. Mounting Template D150
*1 1/8-IN. OUTLINE OF UNIT 16 1/4-IN. *18 3/4-IN. 29 3/4-IN. 5/16 DIA. 1 1/8-IN. *19 3/4-IN. 22-IN. NOTE: * Leg mounting locations for ref (5/16- -18 threads) FIGURE 2. MOUNTING TEMPLATE D150... -
Page 9: Figure 3. Wiring Diagram D150 Dispenser
LIGHTED DISPLAY ICE LEVEL SIGNAL OPTION OPTION GROUND T’ STAT LIGHT MOTOR HEATER OPTION BALLAST LIGHT GATE STARTER SOLENOID 1 1/4 AMP TIME DELAY FUSE AGITATION TIMER 24 V. TRANSFORMER BEVERAGE FAUCET SWITCH Q.C. CONNECTOR (TYPICAL) OPTION TERMINAL BEVERAGE SYSTEM BOARD PORTION TIMER PORTION... -
Page 10: Solenoid Assembly Parts List
FIGURE 4. SOLENOID ASSEMBLY - - EXPLODED VIEW AND PARTS LIST Index Part No. Qty. Name 21493 Solenoid Mounting Plate 31551 Solenoid Service Kit 70171 8- -32 x 3/8 Phil Tr HD Screw 70121 No. 8 Lockwasher 50752 Isolator 50789 Bumper Assembly 70423 Cotter Pin... -
Page 11: Figure 5. Dispensing Levers And Switches
CUP ACTIVATED PUSH LEVER FIGURE 5. DISPENSING LEVERS AND SWITCHES... -
Page 12: Model 3030 Parts List
MODEL D100/D150 PARTS LIST Item No. Part No. Name 21491 Gate Slide 23062 Foam Shield 21515 Depressor Lever 29026 Agitator D100 26591 Agitator D150 30895 Depressor Switch 31007 Switch Boot 32498 Agitator Motor 51859 Motor Shaft Seal 51860 Motor Gasket... - Page 13 CORNELIUS INC. CORPORATE HEADQUARTERS: One Cornelius Place Anoka, Minnesota 55303-6234 (612) 421-6120 (800) 238-3600...