Installation Instructions; Remove Ice Maker From Packaging - Cornelius IMD GLACIER 500-30 Installation Manual

INSTALLATION INSTRUCTIONS

R I
EMOVE CE MAKER FROM
1. Keep the unit in the upright position, first remove the top panel (No:1) of the wooden package by un-stapling/
un-screwing.
2. Remove the staples/screws from the right panel (No:2) of the package to remove the right side panel.
3. Remove the staples/screws from the left panel (No:3) of the package to remove the left side panel.
4. Remove the staples/screws from the front panel (No:4) of the package to remove the front panel.
5. Remove the staples/screws from the back panel (No:5) of the package to remove the back panel.
6. Remove the two bolt (No:6) that secures the unit on the pallet (Can be located at the bottom of the pallet). To
un-bolt it tilt the unit to its side (either left or right) so that the 3/8" (M10) bolts are easy to access.
NOTE: Make sure that the unit side is not touching the floor.
NOTE: To unbolt a Socket head wrench is needed.
7. Inspect the unit for damage, upon inspection of unit, if any damage is found, file a claim with carrier immedi-
ately.
8. Locate Start-up Card either on outside of container or on plastic liner. Fill in proper information and send one
copy to factory, and other copy to Distributor. Postage is prepaid.
NOTE: Do not lay the unit on its side or back. This may cause vital oils to drain from the compressor
resulting in damage during start-up and consequently voiding the warranty
© 2018, Cornelius Inc.
Countertop Icemaker IMD Glacier Series Installation Manual
P
ACKAGING
Figure 2.
- 5 - Publication Number: 620068501INS