Magnum Energy MM-R Series Instruction Sheet

MM-R/MM-RC Remotes Instruction Sheet
Introduction
The MM-R remote allows you to turn the inverter on and off (ON/OFF), and
provides three LED indicators for: inverter status (INVERT), status of any
external AC power (AC IN), and to alert you of any faults (FAULT).
The MM-RC remote includes the remote ON/OFF switch and the same three
LED indicators that the MM-R has, as well as three additional LED indicators
for charger status (BULK, ABSORB, FLOAT).
MM-R
INVERT
AC IN
ON/OFF
FAULT
Figure 1, MM-R and MM-RC Remotes
Installation
Before proceeding, read the entire Installation section to determine how best
to install your remote. The more thorough you plan in the beginning, the
better your inverter needs will be met.
Installation Guidelines
• Before connecting any wires determine the remote's cable route
throughout the home or vehicle/boat, both to and from the inverter.
• Always check for existing electrical, plumbing, or other areas of potential
damage BEFORE drilling or cutting into walls to mount the remote.
• Make sure all wires have a smooth bend radius and do not become kinked.
• If installing this remote in a boat, RV, or truck ensure the conductors
passing through walls, bulkheads, or other structural members are
protected. This minimizes insulation damage (such as chafi ng) which can
be caused by vibration or constant rubbing.
Unpacking and Inspection
Carefully remove the MM-R or MM-RC remote from its shipping container and
inspect all contents. Verify the following items are included:
• MM-R or MM-RC remote display
• 25' Communication cable
• MM-R/MM-RC Instruction Sheet
If items appear to be missing or damaged, contact your authorized Magnum
dealer or Sensata Technologies. Save your proof-of-purchase as a record of
ownership; it is needed if the unit requires in-warranty service.
Part Number: 64-0012 Rev F
Sensata Technologies
www.SensataPower.com
MM-RC
BULK
INVERT
AC IN ABSORB
ON/OFF
FLOAT
FAULT
• Bezel
• Two Phillips screws
1