Machine Safety And General Maintenance; Machine Mounting - KWM Gutterman IronMan Operating And Maintenance Troubleshooting Manual

Read the entire manual prior to operation of this machine.
•
Always keep covers and lids on machine during transportation, operation and storage. The covers are for the
•
operator's safety. Not only will the covers protect the operator against injury, but they will also protect the
machine from outside elements.
Do not transport or store machine with gutter coil in it. The forming rollers have adequate spacing, which will
•
not allow them to come in contact with one another. The polyurethane drive rollers do not need to be protected
from each other.
Read all warning labels on machine.
•
Disconnect the machine from power source prior to cleaning or performing any maintenance.
•
Perform a daily inspection for debris, loose nuts, and/or bolts. With a clean machine, you can expect longer
•
machine life along with a better-finished product.
Lubricate guillotine and chains weekly using waterproof synthetic grease.
•
OUTSIDE STORAGE: If machine must be stored outside, tarp machine loosely in order to provide sufficient
•
ventilation to prevent condensation.
Gear-Box oil level should be inspected annually. The gear oil level should be even with the bottom of the
•
inspection hole.
Be sure that the operator is trained in the operation procedures of this equipment and all local and national
•
safety codes concerning the operation and lifting of coils.
MOUNTING MACHINE IN TRUCK OR TRAILER:
When choosing a vehicle or trailer for your machine, consider the gross machine weight including coil.
•
Check mounting surface for its integrity and make any repairs necessary prior to installation.
•
Bolt machine (in 4 places) to the bed of the vehicle using 3/8" dia. bolts grade 5.
•
Do not draw machine down to an un-flat surface; shim as needed to insure four place mounting.
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
___________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
___________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
___________________________________________________________________
SECTION: 2
SAFETY AND GENERAL MAINTENANCE
SECTION: 3
MOUNTING MACHINE
NOTES:
3