Advertisement

Quick Links

E7202S CONVECTION OVEN
CAUTION: Read the instructions before
using the appliance
INSTALLATION and
SERVICING INSTRUCTIONS
IMPORTANT
The installer must ensure that the installation of the appliance is in conformity with these
instructions and National Regulations in force at the time of installation. Particular attention
MUST be paid to –
BS7671 IEE Wiring Regulations
Electricity at Work Regulations
Health And Safety At Work Act
Fire Precautions Act
This appliance has been CE-marked on the basis of compliance with the Low Voltage and EMC
Directives for the voltages stated on the Data Plate
WARNING -THIS APPLIANCE MUST BE EARTHED
On completion of the installation these instructions should be left with the Engineer-in-Charge for
reference during servicing. Further to this, The Users Instructions should be handed over to the
User, having had a demonstration of the operation and cleaning of the appliance.
IT IS MOST IMPORTANT THAT THESE INSTRUCTIONS BE CONSULTED BEFORE
INSTALLING AND COMMISSIONING THIS APPLIANCE. FAILURE TO COMPLY WITH THE
SPECIFIED PROCEDURES MAY RESULT IN DAMAGE OR THE NEED FOR A SERVICE
CALL.
PREVENTATIVE MAINTENANCE CONTRACT
In order to obtain maximum performance from this unit we would recommend that a Maintenance
Contract be arranged with <?tf="Arial-b">SERVICELINE<?tf>. Visits may then be made at
agreed intervals to carry out adjustments and repairs. A quotation will be given upon request to
the contact numbers below.
WEEE Directive Registration No. WEE/DC0059TT/PRO
At end of unit life, dispose of appliance and any replacement parts in a safe
manner, via a licenced waste handler.
Units are designed to be dismantled easily and recycling of all material is
encouraged whenever practicable.
Falcon Foodservice Equipment
HEAD OFFICE AND WORKS
Wallace View, Hillfoots Road, Stirling. FK9 5PY. Scotland.
SERVICELINE CONTACT
Phone: 01438 363 000
Fax: 01438 369 900
.
T100677 Ref. 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E7202S and is the answer not in the manual?

Questions and answers

Summary of Contents for Falcon E7202S

  • Page 1 E7202S CONVECTION OVEN CAUTION: Read the instructions before using the appliance INSTALLATION and SERVICING INSTRUCTIONS IMPORTANT The installer must ensure that the installation of the appliance is in conformity with these instructions and National Regulations in force at the time of installation. Particular attention MUST be paid to –...
  • Page 2 Warranty Policy Shortlist Warranty does not cover :- Correcting faults caused by incorrect installation of a product. Where an engineer cannot gain access to a site or a product. Repeat commission visits. Replacement of any parts where damage has been caused by misuse. Engineer waiting time will be chargeable.
  • Page 3 SECTION 1 – INSTALLATION UNLESS OTHERWISE STATED, PARTS WHICH HAVE BEEN PROTECTED BY THE MANUFACTURER ARE NOT TO BE ADJUSTED BY THE INSTALLER 1.1 MODEL NUMBER, NETT WEIGHTS and DIMENSIONS MODEL WIDTH mm DEPTH mm HEIGHT mm WEIGHT kg E7202 1.2 SITING The units are suitable for installation upon any flat, horizontal surface.
  • Page 4 1.4 INSTRUCTION TO USER Upon completion of installation, the correct method of operation should be demonstrated to kitchen staff. Location of the main isolating switch should also be indicated, to be used in event of an emergency or during cleaning. SECTION 2 - SERVICING and MAINTENANCE Warning BEFORE ATTEMPTING TO UNDERTAKE ANY MAINTENANCE TASK.
  • Page 5 e) Undo impeller retaining nut (LH thread) and remove impeller. f) Undo fixings that secure motor to oven rear and withdraw. g) Replace in reverse order. 2.1.7 To Remove Neon Indicators a) Open control panel. Refer to Section 2.1.1. b) Remove connections, noting their positions. c) Remove securing nut and withdraw neon.
  • Page 6 a) Undo locknut and remove stud. b) Replace stud and adjust as detailed in Figure 1 before tightening locknut. Figure 1 2.1.15 To Remove Oven Light a) Remove RH shelf hanger. b) Undo lamp cover fixing screws. c) Open control panel. d) Undo lamp wiring connections.
  • Page 7 Control knob Timer/Operating 732920048 Fan switch 732910481 Operating Thermostat 731910500 Safety Thermostat 732910406 Timer 732910414 Lamp Switch 732910548 Neon Amber 730962040 Neon Red 730962010 Lamp c/w Holder 732910350 Oven Fan 535420010 Wiring Diagram E7202...

This manual is also suitable for:

E7202

Table of Contents