Avery Dennison Monarch ADTP2 EcoCut Instructions Manual page 9

L o a d i n g a R i b b o n
Note the ribbon loading as shown.
Rotate the take-up reel until any wrinkles are past the printhead. The ribbon must be straight
and centered throughout the path.
Ta ke-up Reel
M o v i n g t h e C u t t e r t o t h e H o m e P o s i t i o n
Check to see if the cutter is at the "home" position (near the printhead latch).
If it is not, there are several ways to move it
to the "home" position:
♦
Close the printhead (with supply loaded)
and press FEED. The cutter moves to the
home position.
♦
Using a small flat-head screwdriver, turn
the cutter home position screw clockwise
until it stops. The cutter cartridge moves
slightly as the screw turns until it stops at
home.
♦ Using the printer's control panel, press 
or . The cutter cartridge moves to the
other side.
If the cutter cannot be moved, contact
Technical Support.
Turn th e scr ew
Classification: Avery Dennison - Public 9