Avery Dennison Monarch ADTP2 EcoCut Instructions Manual page 10

C l e a r i n g a C u t t e r J a m
If supply jams in the cutter, the display turns red and you see error 759.
1. Press Escape to clear the error. If supply is jammed under the cutter cartridge, manually
move the cutter: Using a small flat-head screwdriver, turn the cutter cartridge's screw
clockwise or counter-clockwise until it is away from the jammed supply.
Clear the supply path to remove jammed supply out of the cutter.
2.
Caution: Do not place your fingers near the cutter's blade.
Clean the supply path if you notice adhesive build-up. See
3.
Supply Path" for more information.
C l e a n i n g A d h e s i v e f r o m t h e S u p p l y P a t h
Clean the printer's supply path regularly (approximately every 60,000 inches) or whenever
adhesive build-up is present. The printer prompts every 60,000 inches as a reminder to clean
the supply path. Only clean the cutter while the printer is idle (no active print jobs).
Adhesive build-up occurs on the
♦
edges of the inner supply guides
♦
sensors
♦
peel bar/cutting anvil
♦
bottom of the ribbon deflector.
♦
cutter blade and depth control roller
To clean the printer's supply path:
1. Open and remove the adhesive
remover wand (132839) from
the package. Do not touch the
foam end of the wand.
2. Use the foam end of the wand
to dampen the inner edges of
the supply guides, sensor, and
underneath the ribbon
deflector.
10 Classification: Avery Dennison - Public
"Cleaning Adhesive from the
Ad h esive build-up ar ea