Avery Dennison Monarch ADTP2 EcoCut Instructions Manual page 8

6. Gently slide the bail all the way onto the reel.
Turn the reel counter-clockwise to remove
7.
any slack in the liner.
Close the printhead assembly until you hear it
8.
click in to place.
Close the peel door.
9.
10. Press FEED to position the supply under the
printhead.
When removing printed labels, always lift up,
using the cutter cover as a guide.
Removing a Full Liner Take-Up Roll
The printer alerts you when the liner take-up reel
is full. The liner take-up reel holds approximately
half of a roll of liner.
Note: The liner can be removed before the take-up reel is full.
1. Open the cover.
Turn the printhead latch to unlock the printhead. Lift the printhead assembly until it locks
2.
into place.
Open the peel door.
3.
Gently pull the liner take-up bail off the liner take-up reel.
4.
Use scissors to cut the liner in front of the take-up reel.
5.
Remove the liner from the take-up reel.
6.
7. Reload supply and continue printing.
8 Classification: Avery Dennison - Public