Cisco UCS E Series Hardware Installation Manual page 52

Installing the EHWIC E-Series NCE into the Router
Figure 25: Installing the Double-Wide EHWIC E-Series NCE in a Cisco ISR G2
1 Double-wide EHWIC E-Series NCE
Caution
Step 4 Using the faceplate, push the EHWIC E-Series NCE into place until you feel the EHWIC seat securely into
the connector on the router backplane. The interface card faceplate should contact the chassis rear panel.
Caution
Step 5
Using a number-1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the EHWIC
E-Series NCE faceplate.
What to do next
What to Do Next
1. Load a compatible Cisco IOS image.
2. Connect the EHWIC E-Series NCE to the network and then power up the router and the NCE.
3. Verify that the router recognizes the EHWIC E-Series NCE. See the
Installation, on page
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
52
Do not touch the EHWIC E-Series NCE board. Handle the EHWIC E-Series NCE by the edges of
the faceplate to reduce the risk of damage to the card.
Do not connect cables to EHWIC E-Series NCE until you have installed it.
53.
2 ISR G2
Verifying EHWIC E-Series NCE