Cisco UCS E Series Hardware Installation Manual page 49

Step 4
Step 5
Step 6
Step 7
Removing Blank Faceplates from the EHWIC Slots
Before You Begin
Make sure that you connect the wrist-strap clip to an unpainted portion of the chassis frame to channel unwanted
ESD voltages to ground.
Procedure
Procedure
Step 1 Using either a number-1 Phillips screwdriver or a small flat-blade screwdriver, unscrew the captive screws
and remove the blank faceplate from the chassis slot you plan to use. See Figure 24 and 25.
1 A blank interface faceplate with double thumb screws.
Step 2 Save the blank faceplates for future use.
What to do next
What to Do Next
Remove the slot dividers from the EHWIC slot. See the
49.
Removing Slot Dividers from EHWIC Slots
Slot dividers are removed to permit use of double-wide EHWIC E-Series NCE in the router slots.
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
Command or Action
Remove the blank faceplate from the EHWIC
slots that you want to use.
Remove the slot divider from the EHWIC slot
for EHWIC E-Series NCE installation.
Install the EHWIC E-Series NCE into the
router.
Verify the EHWIC E-Series NCE installation.
Removing Blank Faceplates from the EHWIC Slots
Purpose
Removing Blank Faceplates from the EHWIC
Slots, on page 49
Removing Slot Dividers from EHWIC Slots ,
on page 49
Installing the EHWIC E-Series NCE into the
Router, on page 50
Verifying EHWIC E-Series NCE Installation,
on page 53
Removing Slot Dividers from EHWIC Slots , on page
49