Canon PowerShot G2 Service Manual page 95

CHAPTER 3. REPAIR INSTRUCTION
4 1. Place the camera so that lens is set against the
light source surface of the Brightness Box via
the C-12 Filter.
2. Set the Brightness Box to EV12.
3. Click the "Check" button.
4. Check the Brightness level if it is within
0 ± 5.
* If not, calibrate the Brightness Box until it
becomes within 0 ± 5.
5. Click the "NEXT" button.
5 1. When the message on the right appears, Set the
Brightness Box to EV15 and attach the ND-8
Filter while setting the C-12 Filter between the
lens.
2. Click the "Check" button.
Check the Brightness level if it is within
0 ± 5.
If not, calibrate the Brightness Box until it
becomes within 0 ± 5.
3. Click the "NEXT" button.
6 When the message on the right appears go to 7.
7 1. Attach the ND-4 Filters between the Lens and
the Color Viewer.
2. Place the camera so that the lens is set against
the center part of the Color Viewer.
3. Click the "ADJUST" button.
C-12 Filter
Personal
Computer
Color Viewer
Personal
Computer
3-50
Brightness
Box
CAMERA
BODY
Power
Source
ND-4
Filter
CAMERA
BODY
Power
Source
Stand