Air Bath Installation - MTI Designer 112 Installation And Operational Manual

Installation and Operational
Installation Instructions – Airbath
1. Select a location for the air blower and system components that meets the conditions noted on
the previous page.
2. Connect the the air hose, keypad cable, and drain sensor wires that exit the bottom of the bath
near the drain to the blower. See photo "A" below.
1
3. If your air system includes LED lights, and/or Radiance®, the control boxes will be placed next to the
blower and plug into the side of the blower. Connect the wires for the lights and heating pads for
Radiance® from the tub to leads that extend from the designated control box. See photo "B" below
1
8
4. Do not crush or kink any of the connections.
5. Extensions: Do not attempt to disconnect any cables extending from the tub. Extensions are
available through MTI's Technical Service Department. See page 8 for more details.
9 / mtibaths.com
Manual ° Designer
PHOTO "A"
2
4
5
PHOTO "B"
2
4
6
5
Collection ° Acrylic Freestanding Tubs
1 - Air blower (remote mounted)
2 - Blower hose
3 - Keypad (installed on tub)
3
4 - Ethernet (keypad) cable
6
5 - Drain sensor wire
6 - Drain sensors - installed on tub
1 - Air blower (remote mounted)
2 - Blower hose
3 - Keypad (installed on tub)
4 - Ethernet (keypad) cable
3
5 - Drain sensor wire
6 - Drain sensors - installed on tub
7 - LED lights - installed on tub
8 - Control box (remote mounted)
7