Table Of Contents - ABB ACS880-34 Series Hardware Manual

Attaching the drive module to the LCL filter module ..........................................
Attaching the drive module and the LCL filter module to the cabinet base ................
Grounding the drive module and the LCL filter module ......................................
Installing the drive in Rittal VX25 enclosure ...................................................
Optional input power cable connection terminals and ground busbar assembly (+H370) .
Drive module without full-size output cable connection terminals (option +0H371) and
IP20 shrouds (option +0B051) ...................................................................
7 Guidelines for planning the electrical installation
Contents of this chapter ...........................................................................
Limitation of liability ................................................................................
Selecting the main supply disconnecting device ..............................................
European Union ................................................................................
North America ...................................................................................
Other regions ...................................................................................
Selecting the main contactor .....................................................................
Examining the compatibility of the motor and drive ...........................................
Protecting the motor insulation and bearings ..............................................
Requirements table ............................................................................
Availability of du/dt filter and common mode filter by drive type .....................
Additional requirements for explosion-safe (EX) motors ..............................
Additional requirements for ABB motors of types other than M2_, M3_, M4_, HX_
and AM_ ......................................................................................
Additional requirements for the regenerative and low harmonics drives ...........
Additional requirements for ABB high-output and IP23 motors ......................
Additional requirements for non-ABB high-output and IP23 motors .................
Additional data for calculating the rise time and the peak line-to-line voltage .....
Additional note for sine filters .............................................................
Selecting the power cables .......................................................................
General guidelines .............................................................................
Typical power cable sizes .....................................................................
Power cable types ..............................................................................
Preferred power cable types ..............................................................
Alternate power cable types ...............................................................
Not allowed power cable types ...........................................................
Additional guidelines, North America ........................................................
Metal conduit ................................................................................
Power cable shield .............................................................................
Selecting the control cables ......................................................................
Shielding .........................................................................................
Signals in separate cables ....................................................................
Signals that can be run in the same cable ..................................................
Relay cable ......................................................................................
Control panel to drive cable ...................................................................
PC tool cable ....................................................................................
Routing the cables .................................................................................
General guidelines - IEC ......................................................................
General guidelines - North America .........................................................
Continuous motor cable shield/conduit or enclosure for equipment on the motor
cable ..............................................................................................
Separate control cable ducts .................................................................
Table of contents 7
69
69
69
69
70
70
71
71
71
71
72
72
72
72
72
73
75
75
75
75
75
75
76
77
77
77
78
78
78
79
80
80
81
81
81
81
82
82
82
82
82
82
82
83
84
84