Kraus Cirrus FUS-13101 Installation Manual

Single lever basin faucet

Advertisement

Quick Links

I N S TA L L AT I O N MA N UA L
Cirrus Single Lever Basin Faucet
FUS-13101
www.kraususa.com I toll free: 1.800.775.0703 I © 2014-2015 Kraus USA Inc. I REV. August 16, 2016

Advertisement

Table of Contents
loading

Summary of Contents for Kraus Cirrus FUS-13101

  • Page 1 I N S TA L L AT I O N MA N UA L Cirrus Single Lever Basin Faucet FUS-13101 www.kraususa.com I toll free: 1.800.775.0703 I © 2014-2015 Kraus USA Inc. I REV. August 16, 2016...
  • Page 2 Thank you for your purchase We would like to take this opportunity to thank you for choosing Kraus. We hope that you are completely satisfied with your purchase, and enjoy it for years to come. If you have any questions, or require technical assistance, please contact us at 800.775.0703 and one of our representatives will be happy to help.
  • Page 3: Prior To Installation

    ∅ • 45mm) ∅ Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800- 1 15/16” ∅ 775-0703 for a replacement 50mm) ∅...
  • Page 4 FUS-13101 Diagram and Parts List A. Faucet Body B. Base O-Ring C. Rubber O-Washer D. Metal U-Washer E. Mounting Screws F. Mounting Nuts G. Hot & Cold Waterlines H. Aerator Assembly H1.Aerator Washer H2.Aerator H3.Aerator Cover...
  • Page 5: Faucet Dimensions

    Faucet Dimensions...
  • Page 6 Lift Rod Drain Diagram and Parts List a. Waste Stopper b. Drain c. Rubber Washer d. Concave Washer e. Plastic Washer f. Mounting Nut g. Tailpipe Washer h. Tailpipe i. Top Hat Washer j. Drain Off Pole k. Washer l. Retaining Nut m.
  • Page 7 Step 1: Install mounting hardware and waterlines Remove faucet, mounting hardware, and waterlines from the box. Remove mounting nuts (F) from mounting screws (E). Place faucet body (A) on a soft cloth, spout facing up. Secure hot & cold waterlines (G) at the base of the faucet (HAND-TIGHTEN ONLY) A.
  • Page 8 Step 3: Secure faucet Install rubber O-washer (C) and metal U-washer (D), over waterlines (G) and mounting screws (F), from underneath the countertop or sink. Attach mounting nuts (F) to mounting screws (E) and tighten with adjustable wrench or 10mm wrench until snug Step 4: Connect waterlines to main valve Thread hot &...
  • Page 9: Step 5: Install Drain

    Step 5: Install Drain • Remove waste stopper (a) from drain (b). Remove tail pipe (h), mounting nut (f ), plastic washer (e), and concave washer (d) from drain (b). Remove retaining nut (l) and washer (k) from tailpipe (h) Installer tip: Leave top hat washer (g) in tailpipe (h) •...
  • Page 10 Step 5: Install Drain • Insert waste stopper (a) into drain (b). Make sure slot at end of waste stopper (a) is facing the rear of the sink • Insert lift pole rod (p) through the hole in the back of the faucet body. Loosen thumb screw (o) and attach extender rod (m) to lift pole rod (p).
  • Page 11 Step 5: Install Drain • Place one end of clip (n) on drain off pole (j). Insert drain off pole (j) through desired hole of extender rod (m). Place other end of clip (n) on drain off pole (j) Installer Tip: You may adjust the extender rod (m) to a desired height Step 6: Flush Faucet...
  • Page 12 7. Aerator Washer 8. Aerator 9. Aerator Cover 10. Base O-Ring 11. Rubber O-Washer 12. Metal U-Washer 13. Mounting Screws 14. Mounting Nuts 15. Cold Waterline 16. Hot Waterline 17. Hex Wrench Download the Kraus Care & Maintenance Guide at: http://www.kraususa.com/maintenance...
  • Page 13 Replacement Part List - Lift Rod Drain 1. Waste Stopper 2. Drain 3. Rubber Washer 4. Concave Washer 5. Plastic Washer 6. Mounting Nut 7. Tailpipe Washer 8. Tailpipe 9. Top Hat Washer 10. Drain Off Pole 11. Washer 12. Retaining Nut 13.
  • Page 14: Troubleshooting

    Trouble - Shooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: P R O B L E M C A U S E A C T I O N Leakage under the Locking nut (5) has Remove cover button...
  • Page 15: Care And Maintenance

    Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 Toll-free 800-775-0703 Customerservice@kraususa.com If you are a plumbing contractor or trade professional please contact a Kraus Pro Representative at: Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 516-801-8955 Proservice@kraususa.com...
  • Page 16 Please take a moment to share your experience. Visit http://www.kraususa.com/review to let us know what you think about your new Kraus product. Contact Us to Learn More 1.800.775.0703 / www.kraususa.com / customerservice@kraususa.com Like & Follow KrausUSA Download the Kraus Care & Maintenance Guide at: http://www.kraususa.com/maintenance www.kraususa.com...

Table of Contents