Yamaha Z200N Service Manual page 304

BRKT
RESERVOIR AND POWER TRIM AND TILT MOTOR
7200
7210
7220
FILLING THE RESERVOIR
WARNING
To prevent the hydraulic fluid from spurt-
ing out due to internal pressure, the tilt
ram should be kept at full length.
1. Fill:
• Reservoir
Recommended power trim and
tilt fluid
ATF Dexron II
2. Check:
• Power trim and tilt fluid level
Level is low → Add power trim and tilt
fluid to the proper level.
BLEEDING THE POWER TRIM AND
TILT UNIT
NOTE:
This bleeding must be done before install-
ing the power trim and tilt unit onto the out-
board.
1. Bleed:
• Air bubbles
(from the power trim and tilt unit)
Bleeding steps
(1) Set the power trim and tilt unit upright.
(2) Connect the leads of the power trim
and tilt on the battery terminals until
the trim and tilt ram assemblies are
fully compressed.
NOTE:
If the rams will not go down, refer to the fol-
lowing.
A. Connect the leads of the power trim and
tilt on the battery terminals until the trim
and tilt ram
extended. Then, reverse the leads on the
battery terminals until the trim and tilt
ram assemblies are fully compressed.
7-25
assemblies are
E
fully