GE CFE29TS Manual page 36

RED Knob LED pulsing .
Time out 30 sec to 'Setup Canceled'
Red knob LED off
Displayed for 3 seconds then to home.
Displays if a hot water system error occurs
Fill Check Mode
• A float switch is used to determine if the tank is full. If the float switch contact is open, the tank is full. If the float switch contact is closed it is not full
however there may still be water in the tank so the fill time may be short.
• If the tank is not full or float switch is closed, the LCD screen will display
starts the Delay Timer of 30 seconds then checks for the T & P switch to be activated before timer times out then displays the
seconds .
• When the T & P switch is activated, the control will start the Maximum Fill Timer of 120 seconds the control turns on the
• The main board will activate the isolation water valve, the door board will activate the Hot Water valve to fill the hot water tank, and the LCD screen will
display the 'Filling'.
• If the T & P switch is released while the tank is being filled the control pulses the
timer will stop counting, both isolation and hot water valves are deactivated and the screen displays
• If the T & P switch is reactivated within the 30 second, the control turn on the
Maximum Fill Timer from the point the T & P switch was released.
• When the tank is full the float switch contact opens and the
Fill Check & Fill Mode
RED Knob LED on
If knob is
Time out 30 sec to
released
'Setup Canceled' Before filled
RED Knob LED pulsing .
Time out 30 sec. to 'Setup Canceled'
'Complete'
Release T&P switch
RED LED
Solid or Pulses
'Hot Water Set up' and the control pulses the
RED LED around the T & P switch, starts a 30 sec. timer, the Maximum Fill
'Filling Paused'.
red LED around the T & P switch, resumes filling and restart the count of the
screen is displayed for 3 seconds then displays the
Note: bypassed if tank is full
Turn and Push
(T & P) switch
RED LED around the T & P switch,
'Setup Canceled' screen for 3
RED LED around the T & P switch.
'Hot Water' screen.
36