Hot Water Dispenser
The 'Turn and Push' (T & P) switch is used to:
• Fill the hot water tank if it is not full such as when unit is first
installed.
• Dispense the hot water once it is heated and ready to dispense.
• Purge the water tank during the Purge Mode if the water
temperature in the tank is higher than the consumer desired
water temperature.
NOTE: The consumer must continuously hold the T & P switch for
the above operations to happen.
The
RED LED
switch is either turned off, turned on solid or
pulsed depending on the hot water operation
mode.
BLUE
operation
around the 'Turn and Push' (T & P)
LED is on during any hot water
Turn and Push
(T & P) switch
33