Adjustable Monitor Stand Capability - NEC AccuSync AS173M User Manual

3. Attach the cable holder onto the monitor stand (Figure 2).
NOTE: To prevent damage to the cables, cable holder, and monitor, spread the cables under the cable holder so that the


cables rest side-by-side.
4. Connect the power cord to a power outlet.
NOTE: •
Please refer to the Caution section of this manual for proper selection of the AC power cord (see


•
Please make sure that enough power is supplied to the monitor. Please refer to
"Chapter 4 Specifications" on page
5. Turn on the monitor by pressing the
6.
hen using the analog (VNA) input, No Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial
setup.
For further adjustments, use the following OSD controlsN
• AUTO CONTRAST
• AUTO ADJUST
Refer to the "OSD Controls List"
NOTE:
If you have any problems, please refer to the

Adjustable Monitor Stand Capability

Hold the monitor on each side and adjust the tilt as desired.
Monitor Stand
Figure 2
21.
button and then turn on the computer.
section of this User's Manual for a full description of these OSD controls.
"Troubleshooting"
English−14
Cable Holder
section of this User's Manual.
page 6).
"Power Supply" in the