Table of Contents
Advertisement
2.3.5 Data Connections
With the cables secured to the cable restraint system and passed through the grommet
seals ensure the supplied wiring card is fitted correctly to the lower section of the rear
cable cover. Insert the 4 green multi connectors into the appropriate slots in the cover.
NOTE: The connectors will only fit in the correct orientation. DO NOT force
them.
The cables can now be cut, stripped and connected to the appropriate terminals on the
connectors using the template. By wiring to the connectors in this position the cable
lengths are all cut to a length suitable for final connection to the AIS main unit.
Use a 2mm or 2.5mm screwdriver to tighten the connectors. Using a larger
!
screwdriver will damage the connector.
When all the required cables are secure pull the connectors from the rear case and remove
the Cable Template.
2.3.6 Blue Sign Switch
When operated in the Inland Waterways mode an external Blue Sign switch can be con-
nected to allow for easy selection of the Blue Sign Mode.
Switch above is shown with Blue sign active.
See the separate Inland Waterways Manual for further information.
28/04/2020
CA2 Installation Manual
Y1-03-0294 Rev. A
15
Advertisement
Table of Contents
