Table of Contents
Advertisement
Cable Restraint Bracket
Attach the restraint bracket to the rear case using the two self tapping screws supplied.
Once all the antenna and data connectors have been routed to the CA2 and cut to length
use the supplied cable ties to secure all cables to the restraint bracket.
2.2.2 Surface Mounting the Transceiver
The transceiver unit can be mounted directly to a suitable flat mounting surface where
access to the rear for cable connection is possible.
Before mounting to an existing surface check the viewing angle details. If
!
uncertain apply power to the unit and test for view-ability before installa-
tion.
Create a cut-out using the template in the centre of this manual and drill 8x mounting
screw holes suitable to take No.6 (3.5mm) self tapping screws(supplied).
NOTE: If the mounting surface is too thin or of unsuitable material for self
tapping screws it is advisable to use M4 stainless steel bolts with nuts
and shake proof washers.
Attach the 4 gasket strips to the rear of the rear cable cover ensuring the tabs locate cor-
rectly to provide a seal.
Feed the required cables through the cable management system and secure leaving ap-
propriate length to complete the connections. Secure the cables to the cable restraint and
then secure the rear cable cover to the mounting surface using the appropriate screws or
bolts.
Take care not to over-tighten the fixing screws to prevent damage to the
!
plastic.
See section 2.2 Making the Connections on page 13 of this manual.
10
CA2 Installation Manual
Y1-03-0294 Rev. A
28/04/2020
Advertisement
Table of Contents
