Table of Contents
Advertisement
MAINTENANCE
WASTE TANK TO CONSOLE
CONNECTION
FOR REPLACING HOSES:
NOTE: Before connecting any hoses to the waste
tanks, make certain the hose clamps are on each
hose.
1. See Figure 3. Connect the 3/4" I.D. water hose
from the water pump on the console to the fitting
on the bottom of the water box. Tighten the hose
clamps.
2. Connect the 3/16" SST hose from the bypass
manifold on the console to the fitting on the
bottom of the water box.
3. Connect the long section of 2-7/8" I.D. (for
Blazer Plus) or 2" I.D. (for Blazer) internal
vacuum hose to the vacuum outlet tube on the
waste tank and to the vacuum pump relief valve
on the console. Tighten the hose clamps.
4. Connect the 2" I.D. waste removal hose to the
2" dia. tube at the bottom of the waste tank.
Tighten the hose clamps.
5. Connect the 5/8" I.D. water hose from the
vacuum heat exchanger on the console to the
fitting on the front bottom of the water box.
Tighten the hose clamps.
6. Connect the 3/4" I.D. water hose from the water
inlet on the console to the fitting on the front top
of the water box. Tighten the hose clamps.
7. Connect the console engine shut-off cord to the
waste tank level sensor cord.
FIRE EXTINGUISHER
We recommend that a fire extinguisher, preferably
rated for A, B, & C type fires, be installed inside the
vehicle.
4-11
BATTERY CONNECTION
FOR BATTERY REPLACEMENT:
Dangerous Acid, Explosive Gases!
Batteries contain sulfuric acid. To prevent acid
burns, avoid contact with skin, eyes, and
clothing. Batteries produce explosive hydrogen
gas while being charged. To prevent a fire or
explosion, charge batteries only in well-
ventilated areas. Keep sparks, open flames, and
other sources of ignition away from the battery
at all times. Keep batteries out of the reach of
children. Remove all jewelry when servicing
batteries.
Before disconnecting the negative (-) ground
cable, make sure all switches are OFF. If ON, a
spark will occur at the ground cable terminal
which could cause an explosion if hydrogen gas
or gasoline vapors are present. When
disconnecting the battery, ALWAYS disconnect
the negative (-) lug FIRST.
1. Remove existing battery and replace with new
battery.
2. Attach the red positive (+) battery cable from the
console starter solenoid to the positive (+) lug on
the battery and tighten the holding nut.
3. Next, attach the black negative (-) battery cable
FROM
GROUND
CONNECTION
ON CONSOLE
from the console ground to the negative (-) lug
on the battery and tighten the holding nut.
BLAZER 980073 09/16/02
BATTERY HOOK-UP
-
BATTERY
FROM
STARTER
SOLENOID
ON CONSOLE
WASTE
TANK
+
Hide quick links:
Advertisement
Table of Contents
